CDA RC 9000 installation instructions Location

Page 29

Location

This cooker has class “2/1” overheating protection so that it can be installed next to a cabinet.

If the cooker is installed adjacent to furniture which is higher than the gas hob cook- top, a gap of at least 200 mm must be left between the side of the cooker and the fur- niture.

The furniture walls adjacent to the cooker must be made of material resistant to heat. The veneered synthetic material and the glue used must be resistant to a temperature of 90°C in order to avoid ungluing or deformations.

The cooker may be located in a kitchen, a kitchen/diner or bed-sitting room but not in a room containing a bath or shower.

Curtains must not be fitted immediatly behind appliance or within 500 mm of the sides.

It is essential that the cooker is positioned as stated below.

The cooker must be installed by a qualified technician and in compliance with local safety standards.

If the cooker is located on a pedestal it is necessary to provide safety measures to pre- vent falling out.

650 mm

500	mm

450 mm
200	mm
200

Fig. 27

29

Image 29

Contents Dual fuel Cookers CDA Contents Assembling the backguard IntroductionGas burners Features and technical dataControl Panel Controls description Control panelElectronic programmer Altering the audible signal Electronic timerElectronic clock fig Normal cooking without the use of the programmerAutomatic oven cooking Semi-automatic cooking Hob burners How to use the hob burnersElectric ignition Lighting of the hob burnersCorrect use of triple-ring burner Choice of burnerOperating principles How to use the Multifunction ovenGeneral features Traditional convection cooking Oven lightHot air cooking GrillingDefrosting frozen foods Convection cooking with ventilation Ventilated grill cookingSimultaneous cooking of different foods SterilizationRegeneration Use of the grill Grilling and au gratinRoasting Important notes Do’s and do not’s For your safetyDo’s and do not’s Flexible tube Care and maintenanceEnamelled parts Triple ring burner BurnersStorage compartment Removal of the inner glass door panelAssembling and dismantling of the side runner frames Inside of ovenOven tray Removing the oven door Door assemblyFor Installer Location Fitting the adjustable feet Levelling the cooker Stability bracket Provison for ventilation Important Note Gas installationGas connection Installation to Natural GasPlug 200 mm 700 mm Conversion to Natural Gas or to LPG Injectors replacement of top burnersAdjusting of the minimum of the top burners Table for the choice of the injectors Lubrication of the gas tapsFeeder cable section Electrical installationConnecting feeder cable Appliance servicing Limit of Cover GuaranteeRC 9000 .. cookers