CDA RC 9000 installation instructions Enamelled parts

Page 22

Enamelled parts

All the enamelled parts must be cleaned with a sponge and soapy water only or other non-abrasive products.

Dry preferably with a microfibre or soft cloth.

Stainless steel, aluminium, painted parts and silk- screen printed surfaces

Clean using an appropriate product. Always dry thoroughly.

Stainless steel surfaces: can be cleaned with an appropriate stainless steel cleaner.

IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abra- sion. You are advised to use a soft cloth and neutral soap.

CAUTION: Do not use abrasive substances or non-neutral detergents as these will irreparably damage the surface.

Changing the oven light

1.Disconnect the electrical power supply (for example, by switching off the main power switch).

2.Unscrew the light cover

3.Fit a new bulb.

4.Refit the cover.

Note:

Use only bulbs designed to resist up to 300°C with the following characteristics: 230 V, type E14 and same power (check watt power as stamped in the bulb itself) of the replaced bulb.

22

Image 22

Contents Dual fuel Cookers CDA Contents Introduction Assembling the backguardFeatures and technical data Gas burnersControl panel Control Panel Controls descriptionElectronic programmer Electronic clock fig Electronic timerAltering the audible signal Normal cooking without the use of the programmerAutomatic oven cooking Semi-automatic cooking Electric ignition How to use the hob burnersHob burners Lighting of the hob burnersChoice of burner Correct use of triple-ring burnerGeneral features How to use the Multifunction ovenOperating principles Oven light Traditional convection cookingDefrosting frozen foods GrillingHot air cooking Ventilated grill cooking Convection cooking with ventilationRegeneration SterilizationSimultaneous cooking of different foods Roasting Grilling and au gratinUse of the grill Important notes Do’s and do not’s For your safetyDo’s and do not’s Care and maintenance Flexible tubeEnamelled parts Burners Triple ring burnerRemoval of the inner glass door panel Storage compartmentInside of oven Assembling and dismantling of the side runner framesOven tray Door assembly Removing the oven doorFor Installer Location Fitting the adjustable feet Levelling the cooker Stability bracket Provison for ventilation Gas installation Important NoteInstallation to Natural Gas Gas connectionPlug 200 mm 700 mm Injectors replacement of top burners Conversion to Natural Gas or to LPGAdjusting of the minimum of the top burners Lubrication of the gas taps Table for the choice of the injectorsConnecting feeder cable Electrical installationFeeder cable section Appliance servicing Guarantee Limit of CoverRC 9000 .. cookers