CDA RC 9000 installation instructions Introduction, Assembling the backguard

Page 4

Introduction

Congratulations on your purchase of this CDA cooker which has been carefully designed and produced to give you many years of satisfactory use.

Before using this appliance it is essential that the following instructions are carefully read and fully understood.

We would emphasise that the installation section must be fully complied with for your safety to ensure that you obtain the maximum benefits from your appliance.

B

Assembling the backguard

■ Remove the two spacers “A” and the screw “B” from the rear of the cook- top.

	■ Assemble the backguard
	as shown in figure 1 and
A	fix it by screwing the cen-
	tral screw “B” and the
	spacers “A”.

Fig. 1

Declaration of CE conformity

✓This cooker has been designed, constructed and marketed in compliance with:

-Safety requirements of EU Directive "Gas" 90/396/EEC;

-Safety requirements of EU Directive "Low Voltage" 2006/95/EC;

-Protection requirements of EU Directive "EMC" 89/336/EEC;GB

- Requirements of EU Directive 93/68/EEC.

4

Image 4

Contents Dual fuel Cookers CDA Contents Introduction Assembling the backguardFeatures and technical data Gas burnersControl panel Control Panel Controls descriptionElectronic programmer Electronic timer Altering the audible signalElectronic clock fig Normal cooking without the use of the programmerAutomatic oven cooking Semi-automatic cooking How to use the hob burners Hob burnersElectric ignition Lighting of the hob burnersChoice of burner Correct use of triple-ring burnerGeneral features How to use the Multifunction ovenOperating principles Oven light Traditional convection cookingDefrosting frozen foods GrillingHot air cooking Ventilated grill cooking Convection cooking with ventilationRegeneration SterilizationSimultaneous cooking of different foods Roasting Grilling and au gratinUse of the grill Important notes Do’s and do not’s For your safetyDo’s and do not’s Care and maintenance Flexible tubeEnamelled parts Burners Triple ring burnerRemoval of the inner glass door panel Storage compartmentInside of oven Assembling and dismantling of the side runner framesOven tray Door assembly Removing the oven doorFor Installer Location Fitting the adjustable feet Levelling the cooker Stability bracket Provison for ventilation Gas installation Important NoteInstallation to Natural Gas Gas connectionPlug 200 mm 700 mm Injectors replacement of top burners Conversion to Natural Gas or to LPGAdjusting of the minimum of the top burners Lubrication of the gas taps Table for the choice of the injectorsConnecting feeder cable Electrical installationFeeder cable section Appliance servicing Guarantee Limit of CoverRC 9000 .. cookers