Henny Penny OGA-341, OFG, OFE, OEA manual Filtering, Shortening

Model OFE/OFG/OEA/OGA-341, 342

3-9. FILTERING	1.	Turn the main switch to the off position. Remove
OF SHORTENING		and clean the fry basket in soap and water. Rinse
		thoroughly.
DRAIN VALVE HANDLE		Best results are obtained when shortening is filtered at
		the normal frying temperature.
	2.	Use a metal spatula to remove any build up from the
		sides of frypot. Do not scrape burner tubes on gas
		models, or heating elements on electric models.
		Scraping the electric fryer elements, or the burner
		tubes of the gas frypot, produces scratches in these
PUMP SWITCH	FILTER UNION	surfaces causing breading to stick and burn.

Figure 3-5

The filter drain pan must be as far back under fryer as it will go, and the cover in place. Be sure the hole in the cover lines up with the drain before opening the drain. Failure to follow these instructions causes splashing of shortening and could result in personal injury.

Surfaces of fryer and baskets will be hot. Use care when filtering to avoid getting burned.

3.Open door(s) under unit, and slowly turn drain

valve handle a half turn. Leave for a few minutes, then

Figure 3-6slowly, fully open drain valve. This prevents much splashing of the hot shortening as it drains. Figure 3-5.

4.As the shortening drains from the frypot, use brushes to clean the sides of the frypot and the burner tubes or heating elements. If the drain fills with breading, use straight white brush to push excess breading into the drain pan.

5.When all shortening has drained, scrape or brush the sides and the bottom of the frypot. Use the lift tool (Figure 3-6) and lift the elements (electric fryers), to clean the bottom of the frypot. Figure 3-7.

Figure 3-7

3-14 406