Henny Penny OFE, OFG, OGA-341, OEA manual C1000 Special Programming

3-6. C1000 SPECIAL PROGRAMMING

1209

Model OFE/OFG/OEA/OGA-341, 342

Special Programming is used to set the items below:

ƒFahrenheit or Celsius

ƒInitialize System

ƒLock or Unlock Controls

ƒFryer Type – Open or Pressure

ƒHeat Source – Electric; Gas w/standing pilot; Gas w/electronic ignition; Gas-Induced Draft

ƒVat Type - Split or Full Vat (frypot)

ƒOil Type - Solid or Liquid

1.To enter Special Programming, turn off power switch

(either side). Press and hold	and turn the power
switch back on.

2.“SPEC” “PROG” followed by, “DEG” “°F” or “°C”. Use

to choose “°F” or “°C”.

3.Press and “INIT” shows in the display.

Press and hold the right and display shows “In-3”, “In-2”, “In-1” followed by “Init Sys” “DONE DONE”. The controls now are reset to factory parameters, the time set to 0:00 and temperature 190°F or 88°C.

4.Press and “LOCK” or “UNLOCK” shows in the

displays. Use		to choose “LOCK” or
“UNLOCK”.
5. Press	and “FRYR” shows in left display and the right
display should show “OPEN”. Use			to change
from “PRES” to “OPEN” if needed.

6.Press and “FRYR” shows in the display. Use

to change the fryer type: “ELEC” for electric models; “GAS” for units with standing pilot; SSI for units with solid state ignition; IDG for units with induced draft gas burners.

7.Press and “VAT” shows in the display. Use

to choose “SPLIT” or FULL” vat (frypot) type.

8.Press and “MELT” and “Solid” or “LIQD” shows in

the displays. Use to choose “Solid”, if using solid shortening, or “LIQD”, if using liquid shortening.

9. Press and hold to exit Special Programming at any time.

3-9