If Shortening Flow is Slow from, Could Result

3-9. FILTERING OF	6.	Rinse the frypot as follows:
SHORTENING		a.	Close the drain valve.
(Continued)		b.	Position return line over empty frypot. Figure 3-8.
		c.	Move the pump switch to the pump position.
		d.	Fill the frypot 1/3 full, then turn off pump.
		e.	Wash down and scrub the sides of the frypot
			with the brushes.
		f.	After the sides and bottom are cleaned, open the
			drain valve.
	7. Close drain valve and pump all of the shortening out of
		the filter drain pan and back into the frypot.
Figure 3-8
		IF SHORTENING FLOW IS SLOW FROM THE
		FAUCET, IT’S POSSIBLE THAT THE FILTER
		CONNECTION AT THE UNION ON THE
		FILTER TUBE IS NOT TIGHTENED
		PROPERLY. IF SO, TURN OFF THE PUMP AND
		WEAR ROTECTIVE GLOVES OR CLOTH
		WHEN TIGHTENING THE UNION. THIS
		UNION WILL BE HOT. SEVERE BURNS
		COULD RESULT.
	8.	When the pump is pumping air only, move the pump
		switch from on to off.
	9.	Check the level of the shortening in the frypot. Add
		fresh shortening if necessary, until it reaches the top
		level indicator line on the rear wall of the frypot.

406

3-15

IF SHORTENING FLOW IS SLOW FROM THE