Henny Penny OFG, OFE, OEA Basic Operations and Procedures, When Filter Lockout , then YOU *MUST

Page 12

Model OFE/OFG/OEA/OGA-341, 342

3-7. BASIC OPERATIONS AND PROCEDURES-

(12 Button Controls/Autolift)

To load product directly into the shortening on Auto-lift

(Continued)

fryers, lower empty basket(s) into the shortening by

 

pressing

, load with product, then press

 

the product button to start the Cook Cycle.

 

Raise the basket(s) on Auto-lift fryers anytime during a

 

Cook Cycle by pressing

. The Timed Cycle

 

then pauses.

 

 

10.At the end of the Cook Cycle, a tone sounds and the

display shows “DONE”. Lift the basket from the shortening. (On auto-lift fryers, the basket(s) automatically rises out of the shortening.) To stop the

“DONE” beeper, press either , or the product button.

A different product can be selected during the first minute of cooking, in case the wrong product button was pressed.

11.The display shows either dashes, or the product name, depending on the Special Program setting, SP-10. If a Quality Time was programmed, the controller alternately shows the product selected and the Quality Time remaining in minutes. If a different product is selected during the Hold Cycle, the display only shows the product selected.

12.At the end of the Hold Cycle, a tone sounds, the display flashes “QUALITY”, and the product it was

timing. Press and release .

In the Cook Mode, when "FILTER SUGGESTED, shows in the display, the operator has the option to filter at this time, or to continue cooking. But, if the operator continues cooking, a filter lockout will occur within the next Cook Cycle, or two.

When "FILTER LOCKOUT" , then "YOU *MUST*

FILTER NOW........” shows in the display,

is the only

button that functions, until the unit is filtered.

 

3-12

903

Image 12
Contents Operating Components Reference Figure C1000 ControlsDescription Function Model OFE/OFG/OEA/OGA-341 408 Operating Controls Button ControlsButton Controls Model OFE/OFG/OEA/OGA-341 903 Filling or Adding Shortening C1000 Operations and Procedures C1000 Operations Procedures Timer ProgrammingSet-Point Temperature Programming C1000 Programmng InstructionsC1000 Special Programming Model OFE/OFG/OEA/OGA-341 Basic Operations Procedures Button Controls/AutoliftBasic Operations and Procedures When Filter Lockout , then YOU *MUST907 Filtering ShorteningWhen Tightening the UNION. this If Shortening Flow is Slow fromFAUCET, IT’S Possible That the Filter Connection AT the Union onFiltering of Shortening Model OFE/OFG/OEA/OGA-341 Cleaning Changing the FilterEnvelope FrypotsFilter pan using the shortening shuttle. Then install AssemblyClose the drain valve. Discard the shortening Filter drain under the fryer, leaving out the filter screenCLEAN-OUT Mode Lighting and Shutdown of the Burners Procedure Frequency