Henny Penny OFG C1000 Operations Procedures, C1000 Programmng Instructions, Timer Programming

Model OFE/OFG/OEA/OGA-341, 342

3-4. C1000 OPERATIONS

AND PROCEDURES

(Continued)

Do not overload, or place product with extreme moisture content into the basket. 18 lbs. (8.2 kgs.) is the maximum amount of product per frypot. Failure to follow these directions can result in shortening overflowing the frypot. Serious burns or damage to the frypot could result.

9.If the right basket was dropped into the shortening, then

press the right .

If the left basket was dropped, then press the left .

10.The timer on the appropriate side (right or left) starts counting down.

The timing operation of the two sides of the control is entirely independent of each other. One may be set, started, or stopped without affecting the other.

3-5. C1000 PROGRAMMNG INSTRUCTIONS

11. At the end of the Cook Cycle a tone will sound and the

display flashes “DONE”. Press button and lift the basket from the shortening.

Timer Programming

1.Anytime the cook time is displayed, press

under the appropriate display to change the cook time.

Set-Point Temperature Programming

1.	Press	once to view the actual shortening
	temperature and press		again to view the set-point
	temperatue.

2.While the set-point temperature is in the display, press

to change the set-point temperature.

If “LOCK” shows in display when pressing , the controls are locked and must be unlocked before changing the time or set-point temperature. See C1000 Special Programming Section.

3-8 408