Henny Penny OFE, OFG, OGA-341, OEA manual Operating Components Reference Figure, C1000 Controls

Model OFE/OFG/OEA/OGA-341, 342

SECTION 3. OPERATION

3-1. OPERATING COMPONENTS Reference Figure 3-1.

C1000 CONTROLS

Fig.	Item	Description	Function
No.	No.
3-1	1	Digital Display	Shows the shortening temperature, the timer countdown in
			the Cook Cycle, and the selections in the Program Mode; the
			temperature of the shortening can be shown by pressing
			once, or twice to view set-point temperature;
			if shortening temperature exceeds 425°F (218°C), the display
			reads “E-5, FRYER TOO HOT”
3-1	2		This LED lights when the shortening temperature is within 5°
			of the setpoint temperature, signaling the operator that the
			shortening temperature is now at the proper temperature for
			dropping product into the frypot
3-1	3		The timer buttons are used to start and stop Cook Cycles
3-1	4		The idle buttons are used to start an Idle Mode which reduces
			the temperature of the shortening during non-use periods;
			press and hold to exit the Idle Mode
3-1	5		The program button is used to access the Program Modes;
			also, once in the Program Mode, it is used to advance to the
			next parameter
3-1	6 & 7		Used to adjust the value of the currently displayed setting
			in the Program Mode and to change set-point temperature for
			the left frypot, or basket
3-1	8 & 9		Used to adjust the value of the currently displayed setting
			in the Program Mode and to change set-point temperature for
			the right frypot, or basket

Proceed onto Section 3-3, Filling or Adding Shortening

408 3-1