Henny Penny OGA-341, OFG, OFE, OEA manual Changing the Filter, Envelope, Cleaning, Frypots

Model OFE/OFG/OEA/OGA-341, 342

3-12. CHANGING THE FILTER

ENVELOPE (Continued)		11.	Fold the corners in and then double fold the open end.
		12.	Clamp the envelope in place with the two filter
			retaining clips.
		13.	Replace the crumb catcher screen on top of the filter
			paper. Screw on the suction standpipe assembly.
		14.	Place complete filter screen assembly back into filter
			drain pan, replace cover, and slide pan back into place
			beneath the fryer.
		15.	Connect the filter union by hand. Do not use a wrench.
		16.	The fryer is now ready to operate.
3-13. CLEANING		After the initial installation of the fryer, as well as before
	THE FRYPOT(S)	every change of shortening, the frypot should be thoroughly
		cleaned as follows:
		1.	Turn the main power switch off.
			The filter drain pan must be as far back under fryer as it
			will go, and the cover in place. Be sure the hole in the
			cover lines up with the drain before opening the drain.
			Failure to follow these instructions causes splashing of
			shortening and could result in personal injury.
			Moving the fryer or filter drain pan while containing hot
			shortening is not recommended. Hot shortening can
			splash out and severe burns could result.
			Always wear chemical splash goggles or face shield and
			protective rubber gloves when cleaning the frypot as the
			cleaning solution is high in alkaline. Avoid splashing or
			other contact of the solution with your eyes or skins.
			Severe burns may result. Carefully read the instructions
			on the cleaner. If the solution comes in contact with
			your eyes rinse thoroughly with cool water and see a
			physician immediately.
		2.	If hot shortening is present in the frypot, drain it by
			slowly opening the drain valve handle, one half turn.
			Leave for a few minutes, then slowly open the valve
			to full open position.
3-18			903