ith the carrier and racks installed on the lid, the lid should down, in contact with the pot rim, when the lid is lowered.
The user will then be able to lock the lid in place. If the lid has a tendency to rise up before getting t
the magnet plate probably needs adjusting
emove the six nuts securing the back shroud and remove back shroud.
2.Loosen the bottom nut under the plate and unscrew both nuts a couple turns, then lower the lid again to see if the lid stays down. If not, repeat procedure.
3.ten lower nut up against the other nut and install back shroud - adjustment is now complete.
This is an electromechanical device that causes pressure to be held in the cookpot. The solenoid valve closes at the beginning of the cook cycle and opens automatically at the end of the cook cycle. If this valve should become dirty, or the Teflon seat nicked, pressure will not build up. The electric fryer uses a 208/240 volt, 60 hertz coil (50 hertz internationally).
starting repair p ump Switch to the ‘
nect main circuit breaker at the circuit breaker box and/or unplug service cord from the wall receptacle or electrical shock could result.
Remove the solenoid wires from the wire nuts which are found behind the control panel. Check across wires.
2081240 Volt, | 60 |
|
2081240 Volt, | 50 | 230 Ohms |