Jackson Specification Information, SPECIFICATIONS of the JP-24/JP-24F, Operating Cycle Seconds

(65.6°C) 150°F (82.2°C) 180°F

(82.2°C) 180°F (198.7L) 52.3 (1.27 cm) 1/2” (3.81 cm) 1 1/2” 20A5 (27L) 7.1

JP-24 Technical Manual 7610-002-49-79 Rev. D

Issued: 03-06-2006 Revised: N/A

2

(21.5) 5.65

SECTION 1: SPECIFICATION INFORMATION

SPECIFICATIONS of the JP-24/JP-24F

PERFORMANCE/CAPABILITIES

OPERATING CAPACITY (RACKS/HOUR)

RACKS PER HOUR

DISHES PER HOUR

GLASSES PER HOUR

OPERATING CYCLE (SECONDS)

WASH TIME

DRAIN TIME

RINSE TIME

TOTAL CYCLE TIME (MINUTES)

5 MINUTE TIMER OPERATING CYCLE (SECONDS)

WASH TIME

DRAIN TIME

RINSE TIME

TOTAL CYCLE TIME (MINUTES)

ELECTRICAL REQUIREMENTS

WASH MOTOR HP 3/4

30

NOTE: Typical Electrical Circuit is based upon (1) 125% of the

600full amperage load of the machine and (2) typical fixed-trip cir-

600cuit breaker sizes as listed in the NEC 2002 Edition. Local codes may require more stringent protection than what is dis- played here. Always verify with your electrical service con- tractor that your circuit protection is adequate and meets all

applicable national and local codes. These numbers are pro-

82	vided in this manual simply for reference and may change
28	without notice at any given time.
10

2	JP-24/JP-24F:
				RINSE		TYPICAL
				HEATER	TOTAL	ELECTRICAL
	VOLTS	PH	HZ	RATINGS	AMPS	CIRCUIT
262	208	1	50	900KW	12	15 AMP
28	230	1	50	1100KW	12	15 AMP
10	208	1	60	900KW	10	15 AMP
5	230	1	60	1100KW	10	15 AMP

TANK CAPACITY (LITERS) (GALLONS)

WASH TANK

TEMPERATURES

WASH --- (MINIMUM)

RINSE --- (MINIMUM)

NOTE: Always refer to the machine data plate for specific electrical and water requirements. The material provided on this page is for reference only and may be subject to change without notice.

WATER REQUIREMENTS

INLET TEMPERATURE

GALLONS PER HOUR

WATER LINE SIZE I.P.S. (Minimum) DRAIN LINE SIZE I.P.S. (Minimum)

FLOW PRESSURE P.S.I. FLOW, GALLONS PER MINUTE