Sears T1KB2/T1RFKB2 manual Prepare the Water System, Style 2 Connection to Water Line

Page 10

Style 2 - Connection to Water Line

1.Unplug refrigerator or disconnect power.

2.Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator.

3.If the gray water tube supplied with the refrigerator is not long enough, a ¹⁄₄" x ¹⁄₄" (6.35 mm x 6.35 mm) coupling is needed in order to connect the water tubing to an existing household water line. Thread the provided nut onto the coupling on the end of the copper tubing.

NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

A

B

C

D

E F G

A. Refrigerator water tubing

 

E. Ferrule (purchased)

B. Nut (provided)

 

 

F. Nut (purchased)

C. Bulb

 

 

 

G. Household water line

D. Coupling (provided)

 

 

 

4.Turn shutoff valve ON.

5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.

Style 3 - Connection to Shut-off Valve

1.Unplug refrigerator or disconnect power.

2.Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator.

3.Thread the provided nut onto the water valve as shown.

NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

A

B

A.Bulb

B.Nut (provided)

4.Turn shutoff valve ON.

5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.

Complete the Installation

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.Plug into a grounded 3 prong outlet.

2.Flush the water system. See “Prepare the Water System.”

NOTE: It may take up to 24 hours for your ice maker to begin producing ice.

Prepare the Water System

Please read before using the water system.

Immediately after installation, follow the steps below to make sure that the water system is properly cleaned.

1.Open the freezer door and turn off the ice maker by lifting up the wire shutoff arm as shown.

NOTE: If your model has a base grille filter system, make sure the base grille filter is properly installed and the cap is in the horizontal position.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

2.Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it for 5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever

(5 seconds on, 5 seconds off) for an additional 2 minutes. This will flush air from the filter and water dispensing system. Additional flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of the dispenser.

3.Open the freezer door and turn on the ice maker by lowering the wire shutoff arm.

■Allow 24 hours to produce the first batch of ice.

■Discard the first three batches of ice produced.

■Depending on your model, you may want to select the maximum ice feature to increase the production of ice.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Side by Side Refrigerator Table of Contents ONE Year Limited Warranty Kenmore Appliance WarrantyDisclaimer of Implied Warranties Limitation of Remedies Before You Throw Away Your Old Refrigerator or Freezer Refrigerator SafetyTake off the doors Unpack the Refrigerator Installation InstructionsClean Before Using Location RequirementsWater Supply Requirements Electrical RequirementsBase Grille Refrigerator Doors Door Closing and AlignmentRemove the Doors Reconnect both ground wires Reconnect wiring plugRemove the Handles optional Replace the Doors and HingesAdjust the Doors Connect the Water SupplyStyle 2 Connection to Water Line Complete the InstallationPrepare the Water System Style 3 Connection to Shut-off ValveRefrigerator USE Using the ControlsAdjusting Controls Normal SoundsWater and Ice Dispensers Crisper Humidity ControlChilled Door Bin On some modelsDispenser Light Water Filter Status LightWater Filtration System Dispenser Lock on some modelsOn some models Accessory Ice Maker and Storage BinConvertible Vegetable/Meat Drawer Crisper and Covers Refrigerator ShelvesDeli Bin Wine RackFreezer Features Door FeaturesDoor Bins CleaningRefrigerator Care Changing the Light BulbsPower Interruptions Vacation and Moving CareTroubleshooting Refrigerator OperationTemperature and Moisture Ice and WaterWater dispenser will not operate properly New installation? Flush and fill the water systemIce dispenser will not operate properly Water is leaking from the dispenserU.S.A AccessoriesWater Filter Certifications CanadaProduct Data Sheet Application Guidelines/Water Supply ParametersÍndice Garantía Limitada DE UN AÑO Garantía DE LOS Electrodomésticos KenmoreExclusión DE Garantías Implícitas Limitación DE Recursos Seguridad DEL Refrigerador Antes de tirar su refrigerador o congelador viejoRequisitos de ubicación Instrucciones DE InstalaciónDesempaque el refrigerador Quite los materiales de empaqueRequisitos del suministro de agua Requisitos eléctricosRejilla de la base Puertas del refrigerador Cómo cerrar y alinear las puertasQuite las puertas Quite las agarraderas opcionalVuelva a colocar las puertas y las bisagras Cómo cerrar la puerta Ajuste las puertasConexión del suministro de agua Alinee las puertasEstilo 3 Conexión a la válvula de cierre Estilo 2 Conexión a la línea de aguaCómo terminar la instalación Sonidos normales USO DE SU RefrigeradorPrepare el sistema de agua Cómo asegurar la debida circulación Del aireControl de humedad del cajón para Verduras Uso de los controlesControl de temperatura del cajón Convertible Depósito enfriador de la puertaPara despachar agua Despachadores de agua y hieloEl despachador de agua El despachador de hieloLa luz del despachador Luz del estado del filtro de aguaSistema de filtración de agua El bloqueo del despachador en algunos modelosUso del despachador sin el cartucho del filtro de agua Fábrica de hielo y depósitoEn algunos modelos Accesorio Para encender y apagar la fábrica de hieloEstantes del refrigerador Características DEL RefrigeradorRecipiente para carnes frías RecuerdeCompartimiento para alimentos Características DEL CongeladorPortabotellas Estante del congeladorRieles o recipientes de la puerta Características DE LA PuertaCuidado DE SU Refrigerador Recipientes de la puertaLuz del panel de control del refrigerador Cómo cambiar los focosLuz del despachador en algunos modelos Luz del cajón para verdurasLuz inferior del congelador en algunos modelos Cortes de corrienteCuidado durante las vacaciones y Mudanzas Si Ud. decide apagar el refrigerador antes de irseSolución DE Problemas Funcionamiento del refrigeradorTemperatura y humedad Hielo y aguaHay fugas de agua del despachador El despachador de hielo no funciona debidamenteEl despachador de agua no funciona debidamente El agua del despachador no está lo suficientemente fríaEn los EE.UU Contratos DE ProtecciónAccesorios En CanadáHoja DE Datos DEL Producto Pautas de aplicación/Parámetros para el suministro de aguaTable DES Matières Garantie DES Appareils Ménagers Kenmore Garantie Limitée DE UN ANAvant de jeter votre vieux réfrigérateur ou congélateur Sécurité DU RéfrigérateurEnlever les portes Déballage du réfrigérateur Instructions D’INSTALLATIONExigences demplacement Enlèvement des matériaux demballageSpécifications électriques Grille de la basePortes du réfrigérateur Raccord du conduitEnlèvement des poignées facultatif Réinstallation des portes et des charnièresEnlèvement des portes Fermeture des portes Ajustement des portesRaccordement de la canalisation deau Alignement des portesStyle 2 Connexion à la canalisation deau Achever l’installationStyle 3 Connexion au robinet darrêt Sons normaux Utilisation DU RéfrigérateurPréparation du système d’eau Pour s’assurer d’une circulation d’air AppropriéeRéglage de lhumidité dans le bac Légumes Utilisation des commandesCommande de température du tiroir Convertible Compartiment froid de la porteDistribution d’eau Distributeurs d’eau et de glaçonsLe distributeur d’eau Le distributeur de glaçonsLe lampe du distributeur Remplacement du filtre à eauSystème de filtration d’eau Le verrouillage du distributeur sur certains modèlesSur certains modèles accessoire Machine à glaçons et bac dentreposageBac pour spécialités alimentaires Caractéristiques DU RéfrigérateurTablettes du réfrigérateur Légumes et couverclesCasier utilitaire Caractéristiques DU CongélateurCasier à vin Tablette de congélateurTringles de la porte ou balconnets Caractéristiques DE LA PorteEntretien DU Réfrigérateur Balconnets de porteLampe du bac à légumes Lampe du tableau de commande du réfrigérateurLampe du distributeur sur certains modèles Fini Ultra Satin apparence inox Laver avec une épongeLampe inférieure du congélateur sur certains modèles Pannes de courantEntretien avant les vacances ou lors ’un déménagement DéménagementDépannage Fonctionnement du réfrigérateurTempérature et humidité Glaçons et eauDe leau suinte du distributeur Le distributeur de glaçons ne fonctionne pas correctementLe distributeur deau ne fonctionne pas correctement Leau du distributeur nest pas assez froideAux États-Unis AccessoiresAu Canada Feuille DE Données SUR LE Produit Système de filtration d’eau à la grille de la base2309568 Sears Brands, LLC

T1KB2/T1RFKB2 specifications

Sears T1KB2/T1RFKB2 is a notable example of a home appliance line that has drawn attention from consumers for its reliable performance and innovative features. Designed for convenience and efficiency, these products represent a sophisticated blend of technology and usability that caters to the needs of modern households.

One of the main features of the T1KB2/T1RFKB2 is their energy efficiency. With growing awareness around energy consumption, these models have been engineered to minimize power usage without sacrificing performance. This not only contributes to lower utility bills but also aligns with environmentally conscious practices.

The T1KB2/T1RFKB2 comes equipped with advanced cooling technologies. This includes variable temperature settings that allow users to customize the cooling experience based on individual preferences or seasonal requirements. The units are designed to maintain consistent temperatures, ensuring optimal conditions for food storage. This consistency is crucial for prolonging the freshness and safety of perishable items.

In terms of design, both models boast an aesthetic that blends well with various kitchen layouts. With sleek, understated finishes, they provide a contemporary look that appeals to consumers. The layout of shelves and compartments within the units is thoughtfully designed to maximize storage space, making organization simpler for users.

Furthermore, these appliances incorporate advanced filtration systems that help in purifying the air inside the unit, ensuring that odors do not compromise the quality of food storage. This feature is particularly beneficial for households that store diverse food items.

Another characteristic of the T1KB2/T1RFKB2 is the user-friendly interface. With intuitive controls and easy-to-read displays, users can effortlessly navigate the settings to adjust temperatures or access different modes. This accessibility makes it suitable for all age groups, ensuring that the entire family can utilize its features without hassle.

Durability is also a hallmark of the T1KB2/T1RFKB2, with high-quality materials used throughout their construction. This ensures that they can withstand the rigors of daily use while maintaining their functionality over time.

In summary, the Sears T1KB2/T1RFKB2 blends energy efficiency, advanced cooling technologies, and user-friendly design in a durable package. These qualities make it a standout choice for families looking for reliable and effective home appliances.
Top Page Image Contents