Sears T1KB2/T1RFKB2 Remove the Handles optional, Remove the Doors, Replace the Doors and Hinges

Page 8

Remove the Handles (optional)

1.Apply firm pressure with your hand on the face of trim. Slide top trim up and bottom trim down away from handle. Lift trim pieces off shoulder screws. See Graphic 1.

2.Remove handle screws and handles. See Graphic 1.

3.Move refrigerator into place. Replace handles as shown. See Graphic 1.

8.Remove the top right hinge cover and screws as shown. See Graphic 6. Do not remove screw A.

9.Lift the refrigerator door straight up and off of the bottom hinge.

10.It may not be necessary to remove the bottom hinge to move the refrigerator through a doorway. Both bottom hinges have similar construction.

■Remove the hinges as shown. See Graphic 7. Do not remove screw A.

Remove the Doors

WARNING

Electrical Shock Hazard

Disconnect power before removing doors.

Failure to do so can result in death or electrical shock.

1.Unplug refrigerator or disconnect power.

2.Open both refrigerator doors. Remove the base grille. Place hands along the ends of the grille. Push in on the top of the base grille and pull up on the bottom. See Graphic 2.

3.Close both doors and keep them closed until you are ready to lift them free from the cabinet.

4.If you have a dispenser (ice or water), disconnect the water dispenser tubing located behind the base grille on the freezer door side. See Graphic 3.

■Press the red outer ring against the face of the fitting and pull the dispenser tubing free.

■On some models, remove the tubing from hose clip.

5.Remove the top left hinge cover and screws as shown. See Graphic 4. Do not remove screw A.

6.Disconnect wiring:

■Disconnect wiring plug.

■Remove green ground wire screw to disconnect ground wires.

C

D

A

B

A. Do not remove screw A

B. Ground wires

C. Green ground wire screw

D. Wiring plug

7.Carefully lift freezer door straight up and off of the bottom hinge. See Graphic 5. The water dispenser tubing remains attached to the freezer door and pulls through the bottom left hinge. Make sure you protect the dispenser tubing from damage.

Replace the Doors and Hinges

1.Replace both bottom hinges, if removed. Tighten screws.

2.Carefully feed the dispenser tubing through the bottom left hinge before replacing the freezer door on the hinge. Assistance may be needed.

NOTE: Provide additional support for the doors while the top hinges are being replaced. Do not depend on the door magnets to hold the doors in place while you are working.

3.Reconnect water dispenser tubing by pushing tubing into fitting until it stops and the red outer ring touches face of fitting. See Graphic 3. On some models, replace tubing in hose clip.

4.Align and replace the top left hinge as shown. See Graphic 4. Tighten screws.

WARNING

Electrical Shock Hazard

Reconnect both ground wires.

Failure to do so can result in death or electrical shock.

■Reconnect both ground wires.

■Reconnect wiring plug.

C

D

A

B

A. Do not remove screw A

B. Ground wires

C. Green ground wire screw

D. Wiring plug

5.Replace left hinge cover and screws.

6.Replace the refrigerator door by carefully lifting the door onto the bottom right hinge.

7.Align and replace the top right hinge as shown. See Graphic 6. Tighten screws.

8.Replace hinge cover and screws. Tighten screws.

9.Plug in refrigerator or reconnect power.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Side by Side Refrigerator Table of Contents Disclaimer of Implied Warranties Limitation of Remedies Kenmore Appliance WarrantyONE Year Limited Warranty Take off the doors Refrigerator SafetyBefore You Throw Away Your Old Refrigerator or Freezer Installation Instructions Clean Before UsingUnpack the Refrigerator Location RequirementsBase Grille Electrical RequirementsWater Supply Requirements Refrigerator Doors Door Closing and AlignmentReconnect both ground wires Reconnect wiring plug Remove the Handles optionalRemove the Doors Replace the Doors and HingesAdjust the Doors Connect the Water SupplyComplete the Installation Prepare the Water SystemStyle 2 Connection to Water Line Style 3 Connection to Shut-off ValveUsing the Controls Adjusting ControlsRefrigerator USE Normal SoundsCrisper Humidity Control Chilled Door BinWater and Ice Dispensers On some modelsWater Filter Status Light Water Filtration SystemDispenser Light Dispenser Lock on some modelsOn some models Accessory Ice Maker and Storage BinRefrigerator Shelves Deli BinConvertible Vegetable/Meat Drawer Crisper and Covers Wine RackFreezer Features Door FeaturesCleaning Refrigerator CareDoor Bins Changing the Light BulbsPower Interruptions Vacation and Moving CareTroubleshooting Refrigerator OperationTemperature and Moisture Ice and WaterNew installation? Flush and fill the water system Ice dispenser will not operate properlyWater dispenser will not operate properly Water is leaking from the dispenserAccessories Water Filter CertificationsU.S.A CanadaProduct Data Sheet Application Guidelines/Water Supply ParametersÍndice Exclusión DE Garantías Implícitas Limitación DE Recursos Garantía DE LOS Electrodomésticos KenmoreGarantía Limitada DE UN AÑO Seguridad DEL Refrigerador Antes de tirar su refrigerador o congelador viejoInstrucciones DE Instalación Desempaque el refrigeradorRequisitos de ubicación Quite los materiales de empaqueRejilla de la base Requisitos eléctricosRequisitos del suministro de agua Puertas del refrigerador Cómo cerrar y alinear las puertasVuelva a colocar las puertas y las bisagras Quite las agarraderas opcionalQuite las puertas Ajuste las puertas Conexión del suministro de aguaCómo cerrar la puerta Alinee las puertasCómo terminar la instalación Estilo 2 Conexión a la línea de aguaEstilo 3 Conexión a la válvula de cierre USO DE SU Refrigerador Prepare el sistema de aguaSonidos normales Cómo asegurar la debida circulación Del aireUso de los controles Control de temperatura del cajón ConvertibleControl de humedad del cajón para Verduras Depósito enfriador de la puertaDespachadores de agua y hielo El despachador de aguaPara despachar agua El despachador de hieloLuz del estado del filtro de agua Sistema de filtración de aguaLa luz del despachador El bloqueo del despachador en algunos modelosFábrica de hielo y depósito En algunos modelos AccesorioUso del despachador sin el cartucho del filtro de agua Para encender y apagar la fábrica de hieloCaracterísticas DEL Refrigerador Recipiente para carnes fríasEstantes del refrigerador RecuerdeCaracterísticas DEL Congelador PortabotellasCompartimiento para alimentos Estante del congeladorCaracterísticas DE LA Puerta Cuidado DE SU RefrigeradorRieles o recipientes de la puerta Recipientes de la puertaCómo cambiar los focos Luz del despachador en algunos modelosLuz del panel de control del refrigerador Luz del cajón para verdurasCortes de corriente Cuidado durante las vacaciones y MudanzasLuz inferior del congelador en algunos modelos Si Ud. decide apagar el refrigerador antes de irseSolución DE Problemas Funcionamiento del refrigeradorTemperatura y humedad Hielo y aguaEl despachador de hielo no funciona debidamente El despachador de agua no funciona debidamenteHay fugas de agua del despachador El agua del despachador no está lo suficientemente fríaContratos DE Protección AccesoriosEn los EE.UU En CanadáHoja DE Datos DEL Producto Pautas de aplicación/Parámetros para el suministro de aguaTable DES Matières Garantie DES Appareils Ménagers Kenmore Garantie Limitée DE UN ANEnlever les portes Sécurité DU RéfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Instructions D’INSTALLATION Exigences demplacementDéballage du réfrigérateur Enlèvement des matériaux demballageSpécifications électriques Grille de la basePortes du réfrigérateur Raccord du conduitEnlèvement des portes Réinstallation des portes et des charnièresEnlèvement des poignées facultatif Ajustement des portes Raccordement de la canalisation deauFermeture des portes Alignement des portesStyle 3 Connexion au robinet darrêt Achever l’installationStyle 2 Connexion à la canalisation deau Utilisation DU Réfrigérateur Préparation du système d’eauSons normaux Pour s’assurer d’une circulation d’air AppropriéeUtilisation des commandes Commande de température du tiroir ConvertibleRéglage de lhumidité dans le bac Légumes Compartiment froid de la porteDistributeurs d’eau et de glaçons Le distributeur d’eauDistribution d’eau Le distributeur de glaçonsRemplacement du filtre à eau Système de filtration d’eauLe lampe du distributeur Le verrouillage du distributeur sur certains modèlesSur certains modèles accessoire Machine à glaçons et bac dentreposageCaractéristiques DU Réfrigérateur Tablettes du réfrigérateurBac pour spécialités alimentaires Légumes et couverclesCaractéristiques DU Congélateur Casier à vinCasier utilitaire Tablette de congélateurCaractéristiques DE LA Porte Entretien DU RéfrigérateurTringles de la porte ou balconnets Balconnets de porteLampe du tableau de commande du réfrigérateur Lampe du distributeur sur certains modèlesLampe du bac à légumes Fini Ultra Satin apparence inox Laver avec une épongePannes de courant Entretien avant les vacances ou lors ’un déménagementLampe inférieure du congélateur sur certains modèles DéménagementDépannage Fonctionnement du réfrigérateurTempérature et humidité Glaçons et eauLe distributeur de glaçons ne fonctionne pas correctement Le distributeur deau ne fonctionne pas correctementDe leau suinte du distributeur Leau du distributeur nest pas assez froideAu Canada AccessoiresAux États-Unis Feuille DE Données SUR LE Produit Système de filtration d’eau à la grille de la base2309568 Sears Brands, LLC

T1KB2/T1RFKB2 specifications

Sears T1KB2/T1RFKB2 is a notable example of a home appliance line that has drawn attention from consumers for its reliable performance and innovative features. Designed for convenience and efficiency, these products represent a sophisticated blend of technology and usability that caters to the needs of modern households.

One of the main features of the T1KB2/T1RFKB2 is their energy efficiency. With growing awareness around energy consumption, these models have been engineered to minimize power usage without sacrificing performance. This not only contributes to lower utility bills but also aligns with environmentally conscious practices.

The T1KB2/T1RFKB2 comes equipped with advanced cooling technologies. This includes variable temperature settings that allow users to customize the cooling experience based on individual preferences or seasonal requirements. The units are designed to maintain consistent temperatures, ensuring optimal conditions for food storage. This consistency is crucial for prolonging the freshness and safety of perishable items.

In terms of design, both models boast an aesthetic that blends well with various kitchen layouts. With sleek, understated finishes, they provide a contemporary look that appeals to consumers. The layout of shelves and compartments within the units is thoughtfully designed to maximize storage space, making organization simpler for users.

Furthermore, these appliances incorporate advanced filtration systems that help in purifying the air inside the unit, ensuring that odors do not compromise the quality of food storage. This feature is particularly beneficial for households that store diverse food items.

Another characteristic of the T1KB2/T1RFKB2 is the user-friendly interface. With intuitive controls and easy-to-read displays, users can effortlessly navigate the settings to adjust temperatures or access different modes. This accessibility makes it suitable for all age groups, ensuring that the entire family can utilize its features without hassle.

Durability is also a hallmark of the T1KB2/T1RFKB2, with high-quality materials used throughout their construction. This ensures that they can withstand the rigors of daily use while maintaining their functionality over time.

In summary, the Sears T1KB2/T1RFKB2 blends energy efficiency, advanced cooling technologies, and user-friendly design in a durable package. These qualities make it a standout choice for families looking for reliable and effective home appliances.
Top Page Image Contents