Replacing the Doors, Connecting the Water Supply

•If tube end is damaged, cut off 5⁄8" before reconnecting.

•If leaking occurs, reconnect the line.

3. Close doors.

4. Remove top hinge covers by removing Phillips screws.

5. Unscrew 5⁄16" hex head screws from top hinges.

For ice and water dispensing models only:

• Do not remove screw connecting green ground wire.

6. For ice and water

dispensing models only: Detach main wire connector harness and red wire harness.

•To detach main wire harness, use a flat blade

tool or fingernail to press junction point between two connectors to release.

• To detach red wire harness,

press tab on underside of connector to release.

7. Remove top hinges along with doors.

8. Remove bottom hinges with a 3⁄8" hex head driver.

Replacing the Doors

•To replace the doors, follow the steps in Door and Hinge Removal in reverse order.

IMPORTANT: If water line tube end is damaged, cut off 5⁄8" before reconnecting.

WARNING

To reduce the risk of injury or death, follow basic precautions, including the following:

•Read all instructions before installing ice maker.

•Do not attempt installation if instructions are not understood or if they are beyond personal skill level.

•Observe all local codes and ordinances.

•Do not service ice maker unless specifically recommended in Use & Care Guide or published user-repair instructions.

•Disconnect power to refrigerator before installing ice maker.

•Water damage due to an improper water connection may cause mold/mildew growth. Clean up spills or leakage immediately!

CAUTION

To avoid property damage or possible injury, follow basic precautions, including the following:

•Consult a plumber to connect 1⁄4" O.D. copper tubing to household plumbing to assure compliance with local codes and ordinances.

•Confirm water pressure to water valve is between 35 and 100 pounds per square inch, 20 pounds per square inch without filter.

•Do not use a self-piercing, or 3⁄16" saddle valve. Both reduce water flow can become clogged over time, and may cause leaks if repair is attempted.

•Tighten nuts by hand to prevent cross threading. Finish tightening nuts with pliers and wrenches. Do not overtighten.

•Wait two to three hours before placing refrigerator into final position to check and correct any water leaks. Recheck for leaks after 24 hours.

•Verify the copper tubing under the sleeve is smooth and free from defects. Do not reuse an old sleeve.