Maytag MZD2665HEQ Dial Temperature Controls, Initial Control Settings, Warm Cabinet Surfaces

Temperature Controls

Dial Temperature Controls

The controls are located at the back left of the refrigerator compartment.

Note

•The freezer control turns the cooling system on. Neither section will cool if freezer control is set to OFF.

Initial Control Settings

After plugging the refrigerator in, set the controls.

• To adjust the controls, turn the control knob to the left or right as desired.

• Set the freezer control on 4.

• Set the refrigerator control on 4.

• Let the refrigerator run at least 8 to 12 hours before adding food.

Warm Cabinet Surfaces

At times, the front of the refrigerator cabinet may be warm to the touch. This is a normal occurrence that helps prevent moisture from condensing on the cabinet. This condition will be more noticeable when you first start the refrigerator, during hot weather and after excessive or lengthy door openings.

Adjusting the Controls

•24 hours after adding food, you may decide that one or both compartments should be colder or warmer. If so, adjust the control(s) as indicated in the Temperature Control Guide table below. See page 16 for instructions on checking compartment temperature.

•Except when starting the refrigerator, do not change either control more than one number at a time.

•Allow 24 hours for temperatures to stabilize.

•Changing either control will have some effect on the temperature of the other compartment.

Temperature Control Guide

Refrigerator too warm	Turn the refrigerator control
	to next higher number.
Refrigerator too cold	Turn the refrigerator control
	to next lower number.
Freezer too warm	Turn the freezer control to
	next higher number.
Freezer too cold	Turn the freezer control to
	next lower number.
Turn refrigerator OFF	Turn the freezer control to
	OFF.

Note

•Turning freezer control to OFF stops cooling in both compartments. It does not shut off power to the refrigerator.

7