GE JCT 915 Using the clock, timer and control lockout, Cleaning, Operating Instructions Care

Page 11

Using the clock, timer and control lockout.

www.geappliances.ca

Safety

Make sure the clock is set to the correct time of day.

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle.

Press the CLOCK pad.

Press the number pads.

Press the START pad.

Instructions

The timer is a minute timer only.

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

To Set the Timer

Press the KITCHEN TIMER ON/OFF pad.

Press the number pads until the amount of time you want shows in the display. For example, to set 2 hours and 45 minutes, press 2, 4 and 5 in that order. If you make a mistake, press the KITCHEN TIMER ON/OFF pad and begin again.

Press the START pad.

When the timer reaches :00, the control will beep 3 times followed by one beep every

6 seconds until the KITCHEN TIMER ON/OFF pad is pressed.

The 6-second tone can be canceled by following the steps in the Special features of your oven control section under Tones

at the End of a Timed Cycle.

NOTE: On some models, the time counts down immediately when the START pad is pressed. The timer is actually counting down in seconds that are not shown on the display until the last minute.

Operating Instructions Care and

To Reset the Timer

If the display is still showing the time remaining, you may change it by pressing the KITCHEN TIMER ON/OFF pad, then press the number pads until the time you want appears in the display.

If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by pressing the KITCHEN TIMER ON/OFF pad and then pressing the number pads to enter the new time you want.

Cleaning

To Cancel the Timer

Press the KITCHEN TIMER ON/OFF pad twice.

Troubleshooting

Control Lockout

Your control will allow you to lock out the touch pads so they cannot be activated when pressed.

To lock/unlock the controls:

Press the 9 and 0 pads at the same time for 3 seconds, until the display shows LOC ON.

To unlock the control, press the 9 and 0 pads at the same time for 3 seconds, until the display shows

LOC OFF.

When this feature is on and the touch pads are pressed, the control will beep and the display will show LOC ON.

The control lockout mode affects all touch pads. No touch pads will work when this feature is activated.

The adjustment will be retained in memory after a power failure.

Tips Consumer Support

11

Image 11
Contents Write the model and serial numbers here Model # Serial # 350A4502P236 229C4020P316 29-503107-02 JROperating Instructions Safety Instructions Important Safety NoticeSafety Instructions Cleaning Operating Instructions Safety InstructionsSafety Instructions Operating Instructions Using the oven controlsCare and Cleaning Troubleshooting Tips Consumer Support Fahrenheit or Celsius Temperature Selection Special features of your oven controlSafety Instructions Tips Care and CleaningConverted temperature of 325F SafetyTone Volume Using Auto Recipe ConversionHow to Exit the Sabbath Feature Using the Sabbath FeatureHow to Set for Regular Baking/Roasting Troubleshooting Tips Care and CleaningCare and Cleaning Using the ovenBroiling Guide Instructions SafetyHow to Set the Oven for Broiling InstructionsOperating Instructions Care Using the clock, timer and control lockoutCleaning How to Set an Immediate Start and Automatic Stop Using the timed baking and roasting featuresCleaning Operating Instructions Support Troubleshooting Tips CareHow to Set the Oven For Roasting When Using the Probe Using the probeTroubleshooting Tips Consumer Support Adapting Recipes… Using the convection ovenConvection Fan Multi-Rack Convection BakingConvection Roast How to Set the Oven for Convection Baking or RoastingInstructions Operating Instructions Tips Consumer SupportCare and Cleaning Operating Instructions Using the timed features for convection cookingInstructions Operating Instructions Care and Cleaning Press the Convection Roast pad Convection Roasting GuideInstructions Operating Instructions Care Using the proofing and warming featuresHow to Set the Oven For Proofing How to Set the Oven For WarmingType of margarine will affect baking performance Adjust the oven thermostat-Do it yourselfCleaning Operating Instructions To Adjust the ThermostatOven must be cool in order to set the self-clean cycle Using the self-cleaning ovenBefore a Clean Cycle How to Set the Oven for CleaningHow to Delay the Start of Cleaning Cleaning Operating Instructions SafetyAfter a Clean Cycle To remove Care and cleaning of the ovenHow to Remove Packaging Tape Oven Light BulbsLift-Off Oven Door Operating Instructions SafetyTroubleshooting Tips Care and Cleaning Cleaning the Oven DoorOven Heating Elements Care and CleaningProbe Oven Racks and Convection Roasting RackStainless Steel Surfaces on some models Control PanelProblem Possible Causes What To Do Before You Call For Service…When you want See the Using the self-cleaning oven sectionDuring clean cycle Not open after a Clean cycleOr letter flash See the Special features of your oven control sectionPower outage A numberTroubleshooting Tips One Year Camco Built-In Electric Oven WarrantyWhat is Not Covered We Will ReplaceContact Us Consumer Support GE Appliances Website Schedule ServiceParts and Accessories Extended Warranties

JCT 915, JCK 915 specifications

The GE JCK 915 and JCT 915 are advanced electric locomotives that exemplify modern engineering and operational efficiency. These models are specifically designed to meet the demands of contemporary rail transport, offering reliability, performance, and reduced environmental impact.

One of the main features of the JCK 915 and JCT 915 locomotives is their powerful traction system. These models are equipped with high-efficiency traction motors that provide excellent acceleration and speed capabilities. This is particularly beneficial for freight services where the movement of heavy loads over long distances is required. The locomotives can operate effectively on various rail gauges, making them versatile for different rail networks.

The locomotives utilize cutting-edge technologies, including advanced diagnostic systems. These systems monitor the health and performance of critical components in real-time, allowing for proactive maintenance and reducing downtime. The integration of onboard data analytics ensures that operators can make informed decisions based on performance metrics, leading to increased efficiency and longevity of the locomotive.

The aerodynamic design of the JCK 915 and JCT 915 also contributes to their operational efficiency. With reduced drag coefficients, these locomotives can achieve higher speeds while consuming less energy. This design consideration aligns with the industry's growing emphasis on sustainability and lowering greenhouse gas emissions.

Safety is a top priority in the design of these locomotives. They come equipped with modern safety features, including advanced braking systems and collision avoidance technologies. The cab design provides improved visibility for the operators, enhancing overall safety during operations.

In terms of comfort, the cab area of the JCK 915 and JCT 915 is designed with the operator in mind. Ergonomic seating, modern controls, and climate control systems create a comfortable working environment, which can significantly enhance operational efficiency.

Moreover, both models are equipped with regenerative braking capabilities. This feature allows the locomotives to recover energy during braking, which can be reintegrated into the system, improving overall energy efficiency.

In summary, the GE JCK 915 and JCT 915 locomotives showcase a blend of power, efficiency, modern safety, and operator comfort. With their advanced features and technologies, they are well-suited to meet the evolving challenges of the rail industry, paving the way for a more efficient and sustainable future in transportation.