
Configuring an M1 CPU with Modsoft
Changing the Delay
Overview | The default value for the delay parameter is 10 ms. This value is appropriate for | ||||
|
| most Momentum applications. | |||
|
| However, if you use baud rates lower than 4800, you should adjust the delay | |||
|
| timing. |
|
|
|
Delay Timing |
|
|
|
| |
If you use baud rates lower than 4800, adjust the delay timing as indicated in the | |||||
|
| following table: | |||
|
|
|
|
|
|
|
| Baud Rate | Delay (in Msec) |
| |
|
|
|
|
|
|
|
| 2400 |
| 20 |
|
|
|
|
|
|
|
|
| 1200 |
| 30 |
|
|
|
|
|
|
|
|
| 600 |
| 50 |
|
|
|
|
|
|
|
|
| 300 |
| 100 |
|
|
|
|
|
|
|
Valid Delay |
|
|
|
| |
The delay must always be a value between 10 and 200 ms, expressed in 10 ms | |||||
Values | increments. | ||||
Procedure |
|
|
|
| |
From the Port editor screen, perform the steps in the following table to change the | |||||
|
| Delay parameter: | |||
|
|
|
| ||
|
| Step | Action | ||
|
|
|
| ||
|
| 1 | Place the cursor on the current Delay entry for the Modbus port. | ||
|
|
|
| ||
|
| 2 | Type a new value in the range 10 ... 200 ms, using 10 ms increments. Push | ||
|
|
| <Enter>. | ||
|
|
| Result: The Port editor screen is updated with the Delay you have specified. | ||
|
|
|
|
|
|
|
|
|
|
|
|
240 | 870 USE 101 10 V.2 |