
Using Peer Cop with Modsoft
Specifying References for Input Data
Introduction | The Peer Cop screen is now set to access the device at Modbus Plus address 2, |
| which for this example is a 170 ADI 340 00 |
| This section explains how to specify the reference for input data from this module. |
Device |
|
When you use Peer Cop to handle a Modbus Plus I/O architecture, you need to be | |
Requirements | aware of the type of I/O you are configuring at each network address. Peer Cop |
| does not know that the device at address 2 is a discrete |
| You need to know that a specific input reference with a length of one word (16 bits) |
| is required to handle this module. |
| We will assign a 3x register (300016) as a specific input to the CPU. When the 170 |
| ADI 340 00 sends input data to the CPU, it will be sent to this register. |
|
|
| Continued on next page |
272 | 870 USE 101 10 V.2 |