GE 164D2966P030 To Set the Clock, To Set the Timer, To Reset the Timer, End of Cycle Tone

Clock

The clock must be set for the automatic oven timing functions to work properly. The time of day cannot be changed during a Timed Bake or CLEAN cycle.

To Set the Clock

	1. Press the	A	2. Press the
CLOCK	CLOCK pad.		INCREASE or
			DECREASE pad
❑		~	to set the time
		n of day.

3. Press the CLOCK pad to start.

Timer

The timer is a minute timer; it does

To Set the Timer

~—~ 1. Press the TIMER

The timer will start automatically

not control oven operations: The maximum setting on the timer is 9 hours and 55 minutes.

TIMER

ONIOFF

ONIOFF pad.

within a few seconds of releasing the INCREASE or DECREASE pad.

The timer, as you are setting it, will display hours and minutes. “HR” will be in the display.

2.Press the INCREASE or DECREASE pad to set the amount of time on the timer.

During the countdown, when the timer reaches the last minute, the display will change to seconds only and a single beep will sound.

To Reset the Timer

If “TIMER” is displayed, press the INCREASE or DECREASE pad until desired time is reached.

If “TIMER” is not displayed, press the TIMER ON/OFF pad first, then follow the instructions above to set the timer.

To Cancel the Timer

Press and hold the TIMER ON/OFF pad until the word “TIMER” disappears from the display.

End of Cycle Tone

The End of Cycle tone is a series of 3 beeps followed by 1 beep every 6 seconds. If you would like to remove the signal that beeps every 6 seconds, press and hold the CLEAIVOFF pad for 10 seconds.

To return the signal that beeps every 6 seconds, press and hold the CLEAWOFF pad for 10 seconds.

Power Outage

After a power outage, when power is restored, the display will flash and time shown will no longer be correct-for example, after a 5-minute power interruption the clock will be 5 minutes slow.

All other functions that were in operation when the power went out will have to be programmed again.

(continued next page)

7