GE JKP7527, JKP3527 Using the clock and timer, Instructions Care and Cleaning, Consumer Support

Using the clock and timer. ge.com

Safety

Make sure the clock is set to the correct time of day.

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle.

Press the Clock pad.

On models with number pads, press them in order to set the correct time of day.

On models with Hour and Min + and – pads, press them to set the correct time of day.

Press the Start pad.

Instructions Operating

The timer is a minute timer only.

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

To Set the Timer

Press the Kitchen Timer On/Off pad.

On models with number pads, press them until the amount of time you want shows in the display. For example, to set 2 hours and 45 minutes, press 2, 4 and 5 in that order.

On models with Hour and Min + and – pads, press them until the amount of time you want shows in the display. The maximum time you can enter in minutes is 59. Cooking times more than 59 minutes should be changed to hours and minutes. For example, enter 90 minutes as 1 hour, 30 minutes.

If you make a mistake, press Kitchen Timer On/Off and begin again.

Press the Start pad.

After pressing the Start pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed. Seconds will not be shown in the display until the last minute is counting down.

When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the Kitchen Timer On/Off pad

is pressed.

The 6-second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.

Instructions Care and Cleaning

To Reset the Timer

If the display is still showing the time remaining, you may change it by pressing the Kitchen Timer On/Off pad, then press the number pads (on some models) or the Hour and Min + or – pads (on some models) until the time you want appears in the display.

If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by pressing the Kitchen Timer On/Off pad and then pressing the number pads (on some models) or the Hour and Min + or – pads (on some models) to enter the new time you want.

Troubleshooting Tips

To Cancel the Timer

Press Kitchen Timer On/Off pad twice.

9

Consumer Support