GE CDW9000 Series, PDW9000 Series, PDW8000 Series owner manual Enhancements, Start

Page 6

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

About the dishwasher control panel.

4Enhancements

The light above the selected pad will be ON to indicate which ENHANCEMENT has been selected.

DELAY HOURS You can delay the start of a wash cycle for up to 24 hours (depending on model). Press the DELAY START pad to choose the number of hours you want to delay the start of the cycle; then press START/RESET.

PDW8000 Series: The machine will count down and start automatically at the correct time.

CDW9000 Series and PDW9000 Series: After closing the door, the machine will count down and automatically start at the correct time.

NOTE: To cancel the DELAY START selection before the cycle begins, repeatedly press the DELAY START pad until the display is blank.

ADDED HEAT When selected, the cycle will run longer with heating element on to improve both wash (EXTRA HOT WASH) and dry performance.

NOTE: Cannot be selected with RINSE ONLY cycle.

PRE WASH For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be (on some models) selected PRIOR to starting the cycle. This option adds 15 minutes to the cycle time.

NOTE: Cannot be selected with RINSE ONLY cycle.

HEATED DRY Shuts off the drying heat option. Dishes will air dry naturally (PDW8900 Series) or

Light Off fan dry (PDW9200–PDW9900 Series and CDW9000 Series) to save energy.

HEATED DRY Turns the heater on for fast drying. This will extend the total cycle time by 15 minutes Light On for the ANTI-BACTERIALcycle, 38 minutes for the NORMAL, SINGLE RACK WASH

and COOKWARE cycles, 8 minutes for the SPEED cycle, 15 minutes for the PLASTICS cycle and 30 minutes for all other cycles.

NOTE: Cannot be selected with RINSE ONLY cycle.

LOCK You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle.

Children cannot accidentally start dishwasher by touching pads with this option selected.

To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds.

The light above the lock pad will turn off. To lock the dishwasher, press and hold the

HEATED DRY pad for 3 seconds. The light above the LOCK pad will turn on.

RESET To change a cycle after washing starts…

PDW8000 Series: Touch the START/RESET pad to cancel the cycle. The START/RESET light will flash while the water is pumped out if needed. This takes approximately 2 minutes.

PDW9000 Series: Open the door slowly to prevent splash-out. Touch the START/RESET pad to cancel the cycle. If the START/RESET light is flashing, close the door until the water pumps out (this takes approximately 2 minutes) and the light stops flashing.

When the light stops flashing, the dishwasher can be reprogrammed and restarted.

5Start

PDW8000 Series

Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad to begin the cycle. Water fill begins immediately, and approximately 60 seconds later the wash action begins.

When the dishwasher door is fully closed and latched, the control panel lights will display the last settings you selected. If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle.

If the door is closed, the indicator lights will turn off if the START/RESET pad is not selected within 5 minutes. To activate the display, open and close the door or press any pad.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Flashing Display Lights Safety InstructionsWrite the model and serial numbers here Model # Serial # You can find them on the tub wall just inside the doorConsumer Support Troubleshooting TipsOperating Instructions On prior to useSupport Operating InstructionsGe.com Troubleshooting Tips Consumer Support Control SettingsSafety Instructions About the dishwasher control panelANTI-BACTERIA Heavy 8.8 gal., 105 min Medium 7.5 gal., 95 min Light 6.3 gal., 85 minNormal Wash Heavy 8.8 gal., 70 min Enhancements StartPDW8000 Series Flashing display lights CleanStatus Indicator Lights What It Means Recommended dishwasher productsUse Jet-Dry or Cascade Crystal Clear Rinse Agent Using the dishwasherCheck the Water Temperature Dish Preparation Prior to LoadingInstructions SafetyManual Detergent Dispenser Filling Manual Detergent DispenserTroubleshooting Tips SmartDispenseTM Detergent Dispenser some modelsSet the door at a comfortable angle to fill the dispenser Close and latch the door lights on, dishwasher not running Determine the Hardness of Your Tap WaterFront controls Top controlsAdjustable Upper Rack Loading the dishwasher racksUpper Rack Silverware Basket Lower RackRemoving the Upper Rack To remove the upper rackLoading place settings… Extra Rack Features on some modelsCaring for the dishwasher Error Messages Possible Causes What To Do Before you call for service…Safety Instructions Operating Instructions Problem Possible Causes What To DoTouch the START/RESET pad again. Repeat if necessary Flatware Make sure water temperature is at least 120FYou are using it. See pages 9 Make sure inlet water temperature is at least 120FControl panel lights Go off when you’reSetting controls Water standing Water won’t pumpWe’ll Cover Any Appliance. Anywhere Anytime GE Service Protection PlusConsumer Product Ownership Registration Page Page GE Dishwasher Warranty For The Period GE Will ReplaceWarrantor General Electric Company. Louisville, KY Consumer Support LaveGE Profile-MDvaisselle Instructions de Fonctionnement Conseils de dépannageSoutien au consommateur Consommateur Fonctionnement Instructions deConseils de dépannage Soutien au Avant de jeter votre vieux lave-vaisselleInstructions de sécurité Le panneau de contrôle du lave-vaisselleRéglage des contrôles Soutien au consommateur Conseils de dépannageConseils de dépannage Soutien au consommateur Choix’efficacité de lavage et d’aseptisation Options Au consommateur Produits de lavage de vaisselle recommandésVoyants lumineux qui clignotent Conseils de dépannage SoutienPréparation de la vaisselle avant son chargement Utilisation du lave-vaisselleVérifiez la température de l’eau Remplissage du distributeurDe dépannage Soutien au consommateur Distributeur manuel de détergentDe sécurité Remplissage du distributeur manuel de détergentDistributeur de détergent SmartDispenseMD certains modèles InstructionsLe montant optimal de détergent Commandes sur le hautTrouvez la dureté de votre eau d’alimentation Après avoir réglé la dureté de l’eau, appuyez surSoutien au consommateur Conseils de Chargement des paniers de votre lave-vaisselleSécurité DépannageEnlèvement du panier supérieur Dépannage Soutien au consommateurPanier inférieur Panier à argenterieChargement des paniers du lave-vaisselle Chargement des couverts…Soins de votre lave-vaisselle SoutienAvant d’appeler le service de réparations… Messages d’erreur Causes possibles Ce qu’il faut faireProblème Causes possibles Ce qu’il faut faire Dans les réservoirs Voile sur les verresDétergent qui reste Du distributeur ouNe fonctionne pas En réglant les commandesLe lave-vaisselle De la cuveOwnership Registration Inscription de propriété de produit de consommation Instructions de fonctionnement Soutien au consommateur Pour une période de GE remplacera Garantie GE sur les lave-vaisselleConseils de Ce qui n’est pas couvertStudio de conception réaliste Soutien au consommateur Service de réparationsPièces et accessoires Prolongation de garantie
Top Page Image Contents