GE GLC4100 owner manual Options, Second time will cancel the Delay Start selection

Page 6

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

About the dishwasher control panel.

3

 

Options

 

 

 

The light above the selected pad will be ON to indicate which OPTION has been selected.

 

 

 

 

 

 

 

 

HOT START

For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be

 

 

(on some

selected PRIOR to starting the cycle. This option will improve both wash and dry

 

 

models)

performance. This option adds 20 minutes to the cycle time.

 

 

 

NOTE: Cannot be selected with RINSE ONLY cycle.

 

 

 

 

 

 

HEATED DRY

Shuts off the drying heat option. Dishes air dry naturally and energy is saved.

 

 

Light OFF

For faster air dry you can prop the door open after the CLEAN light illuminates.

 

 

 

 

 

 

HEATED DRY

Turns the heater on for fast drying. This will extend the total run time by 38 minutes.

 

 

Light ON

NOTE: Cannot be selected with RINSE ONLY cycle.

 

 

 

 

 

 

LOCK

You can lock the controls to prevent any selections from being made. Or you can lock

 

 

 

the controls after you have started a cycle.

 

 

(on some

Children cannot accidentally start dishwasher by touching pads with this option

 

 

models)

selected.

 

 

 

To LOCK the dishwasher control, touch and hold the HEATED DRY pad for 3 seconds. The light below

 

 

 

the HEATED DRY pad will turn on. To UNLOCK the dishwasher control, touch and hold the HEATED

 

 

 

DRY pad for 3 seconds. The LOCK light will turn off.

 

 

 

 

 

 

HOT WASH

When selected, the cycle will run longer with the heating element on to improve both

 

 

 

wash and dry performance. NOTE: Cannot be selected with RINSE ONLY cycle.

 

 

 

 

 

 

DELAY HOURS

You can delay the start of a wash cycle for 2, 4 or 8 hours (delay time options may

 

 

 

vary by model). Touch the DELAY HOURS pad to choose the number of hours you want

 

 

 

to delay the start of the cycle; then touch START/RESET one time. The dishwasher will

 

 

 

count down and start automatically at the correct time. Touching START/RESET a

 

 

 

second time will cancel the DELAY START selection.

 

 

 

 

 

 

RESET

To change a cycle after washing starts, touch the START/RESET pad to cancel the

 

 

 

cycle. The START/RESET light will flash while the water is pumped out if needed. This

 

 

 

takes approximately 90 seconds. When the light stops flashing, the dishwasher can be

 

 

 

reprogrammed and restarted.

4 Start

Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad once to begin the cycle. Water begins to fill the dishwasher, and approximately 60 seconds later the wash action begins. Touching the START/RESET pad a second time will cancel the cycle and cause the water to drain out . This will take approximately 90 seconds.

NOTE: When the dishwasher door is fully closed, the control panel lights will display the last settings you selected.

If you don’t want to change any of the settings, simply touch the START/RESET pad once to begin the cycle.

If the door is closed, the indicator lights will turn off if the START/RESET pad is not pressed within two minutes. To activate the display, open and close the door or touch any pad.

Also, if a power failure occurs or the unit is first plugged into the wall, NORMAL and HEATED DRY will automatically be programmed.

6

Image 6
Contents Write the model and serial numbers here Model # Serial # You can find them on the tub wall just inside the doorOperating Instructions Proper Installation and MaintenanceTroubleshooting Tips Consumer SupportElectrical Requirements Troubleshooting Tips Consumer SupportFor personal safety Ge.comRead and Follow this Safety Information Carefully Proper Disposal of the DishwasherBefore You Throw Away Your Old Dishwasher About the dishwasher control panel Safety InstructionsStatus Indicator Lights CyclesSecond time will cancel the Delay Start selection OptionsStart About the unicouple TipsSupport Use Jet-Dry or Cascade Crystal Clear Rinse Agent Using the dishwasherCheck the Water Temperature Dish Preparation Prior to LoadingInstructions Proper Use of DetergentForget to Add a Dish? NumberLower Rack Loading the dishwasher racksUpper Rack Silverware BasketUpper Rack-12 place settings Loading place settings…Upper Rack-10 place settings Lower Rack-10 place settings Lower Rack-10 place settingsCaring for the dishwasher Cleaning the Door PanelCleaning the Control Panel Protect Against FreezingError Messages Possible Causes What To Do Before you call for service…ge.comSafety Instructions Operating Instructions Problem Possible Causes What To DoBefore you call for service… Warrantor General Electric Company. Louisville, KY GE Dishwasher WarrantyFor The Period GE Will Replace Operating InstructionsConsumer Support Vaisselle Conformité DE L’INSTALLATION ET Entretien Instructions de FonctionnementConseils de dépannage Soutien au consommateur Exigences ÉlectriquesFonctionnement Instructions de Pour votre sécurité personnelleSoutien au Bonne Disposition DE Votre LAVE-VAISSELLEConsommateur Conseils de dépannage Avant de jeter votre vieux lave-vaisselleConseils de dépannage Soutien au consommateur Le panneau de contrôle du lave-vaisselleInstructions de sécurité Voyants lumineux d’étatChaud Soutien au consommateur Conseils de dépannageStart mise en marche Séchage àBranchement de l’Unicouple Débranchement du lave-vaisselleVidange de l’eau en excès des tuyaux de l’Unicouple Préparation de la vaisselle avant son chargement Utilisation du lave-vaisselleVérifiez la température de l’eau DépannageDe sécurité Utilisation correcte du détergentOublié d’ajouter une assiette? InstructionsConseils de Chargement des paniers de votre lave-vaisselleSécurité Au consommateurPanier supérieur-12 couverts Chargement des couverts…Panier supérieur-10 couverts Panier inférieur-10 couverts Panier inférieur-10 couvertsSoutien au consommateur Conseils Soins de votre lave-vaisselleDe dépannage Nettoyage du panneau de la porteAvant d’appeler le service de réparations… Causes possibles Ce qu’il faut faireProblème Causes possibles Ce qu’il faut faire Lave-vaissellenes’est De votre lave-vaisselleMarques noires ou Jamais rempli d’eauPour une période de GE remplacera Toute mauvaise installationGarantie GE sur les lave-vaisselle Ce qui n’est pas couvertStudio de conception réaliste Soutien au consommateur Service de réparationsPièces et accessoires Prolongation de garantie