ge.com
Safety
Screw
Hole
Bulb
Replacing the Light Bulb
Moving the control to COLD does not remove power to the light circuit.
The bulb is located behind the shield in the back wall.
Unplug the refrigerator.
Remove the shelves (if necessary).
Remove the screw.
Gently remove the light shield by inserting a flat head screwdriver into the slot at the top of the shield and pop it off.
Replace the bulb with an appliance bulb of the same or lower wattage.
Insert the tab at the bottom of the light shield into the light bulb housing and snap into place.
Replace the screw.
Replace the shelves if removed.
Plug in the refrigerator.
Instructions Operating
Cover
10’ Refrigerator Light Location
Screw
Hole
Bulb
Cover
12’ Refrigerator Light Location
Preparing for Vacation
For long vacations or absences, remove food and unplug the refrigerator. Clean the interior with a baking soda solution of one tablespoon (15 ml) of baking soda to one quart (1 liter) of water. Leave the doors open.
Preparing to Move
Secure all loose items such as shelves and | Be sure the refrigerator stays in an upright |
drawers by taping them securely in place | position during moving. |
to prevent damage. |
|
7
Instructions
Instructions | Installation |
Troubleshooting Tips Consumer Support