About the shelves and bins. | ge.com |
Not all features are on all models.
Safety
Snugger 
Refrigerator Door Bins and Freezer Door Tilt-Out Bins
Refrigerator bin
Freezer bin
Large Bins
The larger refrigerator door bins and freezer
To remove: Lift the front of the bin straight up, then lift up and out.
To replace or relocate: Engage the back side of the bin in the molded supports of the door. Then push down on the front of the bin. Bin will lock in place.
Small Bins
To remove: Lift the front of the bin straight up then out.
To replace: Position the bin above the rectangular molded supports on the door. Then slide the bin down onto the support to lock it in place.
The snugger helps prevent tipping, spilling or sliding of small items stored on the door shelf. Place a finger on either side of the snugger near the rear and move it back and forth to fit your needs.
Do not block CAUTION: On
models with an ice chute inside the top freezer door bin, be careful when placing items in the bin. Make sure that items do not block or fall into the ice chute.
Freezer tilt-out bin
Instructions Operating Instructions Installation Instructions
Press tab and pull shelf forward to remove
Slide-Out Spillproof Shelf
The
To remove:
Slide the shelf out until it reaches the stop, then press down on the tab and slide the shelf straight out.
To replace or relocate:
Line the shelf up with the supports and slide it into place. The shelf can be repositioned when the door is at 90° or more. To reposition the shelf, slide the shelf past the stops and angle downward. Slide shelf down to the desired position, line up with the supports and slide into place.
Make sure you push the shelves all the way back in before you close the door.
Troubleshooting Tips Consumer Support
7