The Oven side linings
The oven has removable oven side lining panels that have been coated with special enamel that partly cleans itself. This does not stop all marks on the lining, but helps to reduce the amount of manual cleaning needed.
The self cleaning panels work better above gas Mark 6. If you do most of your cooking below this temperature, occasionally remove the panels and wipe with a lint free cloth and hot soapy water. The panels should then be dried and replaced and the oven heated at Gas Mark 7 for about one hour. This will ensure the self cleaning panels are working effectively.
Don’t use steel wool (Brillo) or any other materials that will scratch the surface. Don’t use oven cleaning pads.
Before cleaning the oven, cover the burner at the rear to stop the holes getting blocked as you clean. If they are accidentally blocked, clean them out with thin wire, such as fuse wire.
Removing the Oven Linings
The lining panels can be removed for cleaning and for cleaning behind. Remove the shelves first.
Each side of the oven is fixed with four fixing screws. You don’t have to remove the screws to remove the oven linings. Lift each side panel upwards and they will slide off the screws. Then pull them forwards.
Once the linings are removed, the oven enamel interior can be cleaned.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy, two people may be required to move it. The cooker * fitted with one roller at the front and two at the back. There are also two screw down levelling feet at the front.
The front roller, designed for moving the cooker can be wound down. The levelling tool which controls this roller is in the storage drawer compartment.
Remove the storage drawer (by pulling it right out and lifting it up slightly) and you should see the levelling tool.
Your installer may not have left the levelling tool in place. If not, locate it as shown. If you cannot find the levelling tool, contact your installer.
See the front of the installation section of these instructions.
Turn the levelling tool clockwise, two full (180°) turns. It will be stiff. The front of the oven will rise slightly as the roller drops down.
Open the grill door and right hand oven door so that you can get a good grip on the bottom of the fascia panel as you move the oven.
Do not move the oven by pulling the hand rail, door handles or knobs.
16