Rangemaster Classic 110 Pressure testing, Electrical Connection, Electrical checks, Grill check

Page 28

gas leaks do not use washing up liquid - this can corrode. Use a product specifically manufactured for leak detection.

Pressure testing

The gas pressure can be measured at the injector of one of the LH hotplate burners. Remove the pan support, burner head and caps. The injector is now accessible.

For Natural Gas cookers the pressure should be 20mbar.

For LP Gas cookers the pressure should be 29mbar for Butane

37mbar for Propane.

Reassemble burner top, making sure it is reassembled in the correct way on the burner body.

Electrical Connection

WARNING: THIS COOKER MUST BE EARTHED. All external wiring must comply with the IEE Regulations for the Electrical Equipment of Buildings. Connection to the electrical supply can be made with either a plug and socket or be permanently wired via a double pole switch. The cooker is supplied with a 3 core cable 2m long. If a replacement cable is fitted it must be 250v high temperature PVC (85°C), 1mm 2. Should the plug not fit the socket in your home, it should be removed and replaced with a suitable plug. Note: If a plug is fitted which is not suitable, it must be cut off and disposed of properly. To avoid the risk of electrocution, the plug must not be left where children might find it and plug it into a supply socket.

Three pin plugs to BS1363 with a capacity of not less than 13A must be used and fitted with a 3 amp fuse ‘ASTA’ approved to BS 1362.

After replacing the fuse the cover must be refitted. If the cover is lost, the plug must not be used until a replacement cover has been obtained from your supplier. The colour of the correct fuse carrier is that of the coloured insert in the base of the fuse recess, or stated elsewhere on the plug. Always state this colour when ordering a replacement fuse carrier. IMPORTANT The wires in the mains lead are coloured in accordance with the following code:-

GREEN AND YELLOW: EARTH

BLUE: NEUTRAL

BROWN: LIVE

The wires should be connected into the terminal of your plug as shown:

Electrical checks

EARTH CONTINUITY CHECK

The cooker must be disconnected from the power supply. Set your meter to (ohm) on the X1 scale and adjust to zero if necessary.

Test the leads from any of the cooker’s earth points (e.g. inside electric box cover) - to the earth pin on the cooker’s plug - resistance should be less than

l (ohm). If it is not, check all the earth wires for continuity. Check that all contacts are clean and tight. Re-check. If the resistance is still greater than l (ohm) there may be a problem, consult a qualified electrical engineer.

POLARITY CHECK

The cooker must be connected to the power supply. Your meter should be set on 300V ac scale.

Test at the cooker terminal block:

1.Test leads from L to N. Your meter should read approx. 220-240V ac.

2.Test leads from L to E. Your meter should read approx. 220-240V ac.

3.Test leads from N to E. Your meter should read approx. 0-15V ac.

If the readings are different from these values there is an electrical fault. Rectify any fault and repeat the test. If necessary repeat the test at the supply system socket/spur - if the fault also occurs at this stage then there is a house system fault which requires attention by the Electrical Authority.

The customer should be warned NOT to use the appliance until this examination has been carried out.

Grill check

Open the grill compartment door.

Natural gas models

Press in the grill knob, turn to the large flame symbol ( ) and press the igniter button or light with a match.

LP gas models

LP gas models have an FSD with stops the flow of gas to the grill if the flame goes out. Turn the knob to the large flame symbol ( ). Press in the grill knob. This lets gas through to the burner. Keep holding the knob pressed in and press the igniter button or light with a match. Keep holding the button for about 10 seconds

If when you let go of the control knob the burner goes out, the safety device has not held in. Turn off the grill and wait one minute then try again this time holding in the button for slightly longer.

Hotplate check

Check each burner in turn. Push in each knob and turn it to the large flame symbol. Press the IGN button, release the button when the burner lights.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Classic 110 Gas Users Guide Installation Instructions U1 208 Contents Minute Tour Minute Tour Griddle More about the griddle onNatural gas cookers Minute Tour continues overLP gas cookers To set the time of day Slow cooking Griddle Hotplate burners WarmerGrill Ovens Oven shelves Handyrack‘S’ setting is a low temperature setting ‘S’ Slow cookingOven cooking guide Mark From TOP Approximate Cooking TimeCooking using the timer Clock To time something that’s cooking minute minderCleaning your cooker Hotplate burnersGriddle WarmerGrill Control Panel and DoorsMoving your cooker Oven side liningsPage Troubleshooting Troubleshooting General Safety Instructions If YOU Smell GASThis appliance is heavy, take care when moving it Installation BelowProvision of Ventilation Location of CookerElectric drill Masonry drill bit You will also need the following toolsRawlplugs Positioning the Cooker Unpacking the CookerMoving the Cooker Checking the partsLevelling Fit the HandlesFitting the splash back Fitting a stability bracketGas Connection OptionalPressure testing Electrical ConnectionElectrical checks Grill checkFitting the oven burner trim Oven checkFitting the plinth Customer careCircuit Diagram Technical Data DimensionsThis cooker is designed for use on either Connections

Classic 110 specifications

The Rangemaster Classic 110 is a quintessential choice for culinary enthusiasts who are seeking a combination of traditional design and modern performance in their kitchen. This freestanding range cooker brilliantly marries aesthetics with functionality, making it a centerpiece for any cooking space.

One of the standout features of the Classic 110 is its impressive dual fuel system. It combines a gas hob with an electric oven, offering the best of both worlds. The gas burners provide instant heat and precise temperature control, while the electric oven allows for even baking, roasting, and grilling, thanks to its fan-assisted design. This dual system caters to a variety of cooking techniques, enhancing versatility in meal preparation.

The Classic 110 has a generous cooking capacity with five gas burners up top, including a powerful wok burner for those who love stir-frying. The hob design is not only functional but also features cast iron supports, offering stability and durability. The spacious oven compartment is divided into two distinct ovens, allowing for multiple dishes to be cooked simultaneously at different temperatures.

In addition to its cooking prowess, the Rangemaster Classic 110 is equipped with advanced technologies that enhance the cooking experience. The integrated programmable timer allows users to set cooking times, ensuring meals are prepared to perfection. Its easy-clean enamel interior makes maintaining cleanliness simple and hassle-free.

Another remarkable aspect of this range cooker is its style and finish. The Classic 110 is available in a variety of colors and finishes, including sleek chrome details and elegant handles that add a touch of sophistication to any kitchen décor. The traditional design elements combined with modern functionality create an appealing aesthetic that is both timeless and contemporary.

Safety features are also paramount in the design of the Classic 110. This range cooker incorporates flame failure devices that automatically shut off the gas supply if the flame goes out, providing peace of mind while cooking.

In summary, the Rangemaster Classic 110 is an impressive cooker that offers exceptional performance, a multitude of features, and a stylish design. Its combination of gas and electric cooking capabilities, alongside user-friendly technologies and safety measures, makes it a cherished tool for any home chef.
Top Page Image Contents