Unified Brands VENTILATION SYSTEMS specifications For The Name And Location Of The Nearest

Page 33
FOR THE NAME AND LOCATION OF THE NEAREST

NOTE: AVTEC INDUSTRIES recognizes readings taken at the surface and not at the duct opening. Please refer to the Air Movement Recording Worksheet for proper location(s) to take readings.

WARRANTY-

AVTEC INDUSTRIES INC. warrants to the original purchaser for use of our products, that any part thereof which proves to be defective in material or workmanship under normal use within one year from date of installation, will be replaced free of charge, labor to replace such part is warranted for one year from installation. All warranty labor to be performed during regular working hours, with no overtime premium.

All Warranty service must be authorized by the factory and be performed by AVTEC's authorized service

personnel.

This Warranty is limited to the United States and Canada.

This Warranty does not apply to any damage resulting from shipping, improper installation, accident, unauthorized alteration, local codes not previously brought to the attention of AVTEC, misuse, or abuse; and does not cover loss of food, other products or damage to equipment or property resulting from mechanical or electrical failure.

AVTEC neither makes nor assumes and does not authorize any other person to assume any other obligation or

liability in connection with its products other than that covered in this Warranty.

FOR THE NAME AND LOCATION OF THE NEAREST

AVTEC SERVICE AGENCY, CALL OR WRITE TO:

AVTEC INDUSTRIES INC. 120 KENDALL POINT DR. OSWEGO, IL 60543-8898 630-851-4800

LOCAL SERVICE AGENCY

orm no. 14019 rev 02/01 1998 Avtec Industries Inc.

30

Page 32 Page 33
Image 33
Page 32 Page 33
Contents OPERATORS MANUAL VENTILATION SYSTEMS1055 Mendell Davis Drive Jackson, MS 888-994-7636,fax avtecind.comTABLE OF CONTENTS Air Adjustment Baffle VENTILATOR FEATURES AND ACCESSORIESPERIODIC MAINTENANCE G. Fusible Link Replacement1I. TYPES OF SYSTEMS Installation shall be in accordance with NFPA NOTE Welds must not impede operation of damper Page Page Fig 8a Fig 8b 9.Terminal Block #11 TB-11has three 3 pairs of terminals. The first pair of terminals are low voltage connections for the detergent low level probe. The probe should be installed in the detergent container so that it does not protrude above the top of the detergent pump inlet strainer. fig. #9 This is intended to prevent cavitation of the pump and will advise when the tank needs to be refilled. The probe rods may be cut to facilitate a neat and effective installation For authorized sevice techinician use only Terminal Block DesignationError! Not a valid link Page VI. OPERATION vac as long as the START Button is depressed a. Fan Start b. Setting the PAWS d. Reviewing The Daily Event Schedule OFF/WASH Page l. Detergent Pump and Tank Refer to fig E. Fire Dampers 1. Fusible Link Type fig. 3. Slot-TypeInternal Air Make-Up D. Grease Collection Receptacle B. VCW PANEL - ELECTRICAL A. PAWS PANEL - ELECTRICALC. PAWS/VCW PANEL - PLUMBING ITEM NOE. ELECTRO - MECHANICAL DAMPER D. EVAC DETERGENTITEM NO DESCRIPTIONG. HOOD CANOPY F. FUSIBLE LINK DAMPERITEM NO AVTEC PART NOCleaner/Degreaser Cleaner/DegreaserFor Exhaust Ventilator Auto-washCleaner UNIQUE, POWERFUL CLEANING FORMULAProject Name AIR MOVEMENT RECORDINGSA. ENERGY AIRE HOODS - EXHAUST B. FILTER HOODS - EXHAUSTPage CALCULATING AND RECORDING AIR MOVEMENT EXHAUSTSUPPLY FOR THE NAME AND LOCATION OF THE NEAREST AVTEC SERVICE AGENCY, CALL OR WRITE TO
Top Page Image Contents