White-Westinghouse 218954301 manual Automatic Ice Water Dispenser

Automatic Ice and

Water Dispenser (continued)

WHITE WESTINGHOUSE ICE AND WATER FILTER SYSTEM

SYSTEM SPECIFICATION AND DATA SHEET

APPLICATION GUIDELINES / CONDITIONS OF USE

WATER SUPPLY:	Municipal or Well applications
WATER
TEMPERATURE:	Maximum 100° F. (38° C.) For cold water use only
WATER
PRESSURE:	125 psi maximum Recommended Minimum: 30 psi, as measured at the valve inlet

∙Timely cartridge replacement is essential for the product to perform as advertised. Please refer to the Use and Care Manual for general operation and maintenance requirements. Your refrigerator will have one of two types of filter replacement reminders. One is a simple slide knob on the rear control box that you set to six months after installing a new filter. The other is an electronic light on the freezer door dispenser that lights up yellow when the filter is almost ready for replacement and lights up red when the filter must be replaced. The indicator is pressed for approximately 10 seconds to reset after replacing the filter.

∙Ice & Water Filter System RF-200 should not be used on water that is microbiologically unsafe or with water of unknown quality without adequate disinfection before or after the system. System may be used on disinfected waters that may contain filterable cysts.

∙Performance may vary based on local water conditions and/or pressure. High sediment areas may require more frequent filter replacement.

∙Ice & Water Filter System will absorb bad tastes and odors in both ice cubes and drinking water.

SYSTEM SPECIFICATIONS

FLOW RATE:	Ice Maker - 3.4 to 4.3 oz (99 - 125 cc) per 7.5 seconds at 60 psi (as measured at valve inlet)
	Dispenser - 60 oz per minute (.37 gpm or 1.4 liters per minute) at 60 psi (as measured at valve
	inlet)
CAPACITY:	200 Gallons
SYSTEM	Filter Housing Assembly - ABS Plastic
CONSTRUCTION:	Water Storage Tank - Polypropylene Plastic
	Tubing - Polypropylene / Polypropylene Plastic
	Filter Media - Extruded Carbon block with Polypropylene prefiltration shells

REPLACEMENT CARTRIDGE INFORMATION

Replacement RC-200 Cartridges are available through your local dealer.

General testwater parameters; pH = 7.5 +/- 0.5 Temp. 20°C +/- 3°C (68°F +/- 5°F) Pressure = 60 psi

Substance Reduction

Chlorine

Lead-6.5PH

Lead-8.5 PH

Atrazine

2,4 D

Cysts

Particulates

Turbidity

Particle Size

Range

(microns)

N/A

N/A

N/A

N/A

N/A

3 to 4

.5 to 1

23 - 28 NTU

Average

Influent

1.9mg/l 0.15 mg/l 0.16 mg/l

.0099 mg/l

0.32mg/l

122500 ppm

240000 ppm

26 NTU

Maximum

Effluent

0.11mg/l 0.001 mg/l 0.003 mg/l

.0006 mg/l

0.04mg/l

20 count/pm

880 ppm

0.09NTU

Average

Effluent

0.04mg/l 0.001 mg/l 0.002 mg/l

.0005 mg/l

0.018 mg/l

10count/pm 410 ppm

0.07NTU

Average

%

Reduction

97.80%

99.30%

98.75%

94.90%

94.20%

99.99%

99.80%

99.70%

EPA

M.C.L.

N/A

15.0ug/l

15.0ug/l 3.0 ug/l 70 ug/l

N/A

N/A

N/A

Minumun

%

Reduction

94.80%

99.20%

97.90%

92.60%

85.20%

99.98%

99.50%

N/A

11