Smeg A1-6 manual Installation of the Appliance, Electrical connection

Page 4

Instructions for the installer

2. INSTALLATION OF THE APPLIANCE

It is the law that all gas appliances are installed by competent persons. Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990.

It may be installed against walls one of which is higher than the worktop surface, at least 50 mm from the side of the appliance, as shown in the installation class drawings A and B. Wall units or extractor hoods installed above the appliance's work-top must be at least 750 mm above it.

A

SLOT IN

FREE STANDING

2.1 Electrical connection

B

Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

The plug at the end of the power cable and the wall socket must be the same type (conforming to regulations in force). Check that the power line is adequately grounded. Do not use reducers, adapters or shunts.

On the power line, install an omnipolar cut-off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit.

If the power cable is replaced, the wire section on the new cable must not be less than 1.5 mm2 (3 x 1.5 cable), keeping in mind that the end to be connected to the hob must have the ground wire (yellow-green) longer by at least 20 mm. Use only the special cables available at our Service Centres.

38

Image 4

Contents Contents Introduction Instructions for Safe and Proper USEPlate Must not be Removed Electrical connection Installation of the ApplianceThis rating plate must never be removed Ventilation requirements Replacement of nozzles on the hob Adaptation to Different Types of GASBurner and nozzle characteristics table Arrangement of burners on cooking hobFinal Operations Adjustment of minimum for natural gasRegulation of minimum for LPG Positioning and levelling of the appliance Mounting the rear top upstandDescription of Symbols Thermostat Knob Selection of cooking temperature is carriedFunction Switch Knob Description of ControlsCooking HOB Burner Command Knob Delayed start cooking Manual mode cookingAnalog Programmer Regolazione delloraElectronic Analogue Clock on some models only Setting the timeList of Functions Minute-minder Programming Demo Function USE of the Cooking HOB Lighting of the cooking hob burnersUSE of the Oven Practical advice for using the cooking hob burnersDiameter of containers Cooling fan system Oven LightStorage drawer Available Accessories Function Switch Thermostat Selector Switch from 50 to 250C Cooking HintsTraditional cooking Hot-air cookingGrill cooking Function Switch Thermostat Switch AT MaximumMake sure that the oven door is closed during cooking Function Switch Thermostat Switch from 50 to 250C Function Switch Thermostat Switch in PositionHot-air grilling DefrostingFunction Switch Thermostat Switch from 50 to 200C Spit cookingTraditional Cooking Recommended cooking tableHOT-AIR Cooking Cleaning stainless steel Cleaning and MaintenanceCleaning of cooking hob components Cleaning of the oven Do not USE a Steam JET for Cleaning the Inside of the OvenBurner caps, flame cap crowns and burners Ignition plugs and thermocouplesSelf-cleaning liners Using the self-cleaning linersLooking after the self-cleaning liners Assembling the self-cleaning linersExtraordinary Maintenance Replacement of light bulbOven door seal Removing the doorLubrication of gas taps