Smeg A1-6 Final Operations, Adjustment of minimum for natural gas, Regulation of minimum for LPG

Page 8

Instructions for the installer

4. FINAL OPERATIONS

After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids.

After adjustment to a different kind of gas from the one for which the cooker has been tested, replace the plate inside the storage compartment with one corresponding to the new kind of gas. This plate can be obtained from your nearest Authorised Assistance Centre.

4.1Adjustment of minimum for natural gas

Light the burner and take it to the minimum. Remove the gas tap knob and turn the

adjustment screw inside or at the side of the tap shaft (depending on the model) until there is a regular minimum flame. Replace the knob and check burner flame stability: (rapidly turning the knob from maximum to minimum position, the flame should not go out). Repeat the operation on all the gas taps.

4.2 Regulation of minimum for LPG

For regulating the minimum with LPG, the screw at the side of the tap rod must be turned clockwise all the way.

The bypass diameters for each individual burner are shown in paragraph “3.2 Burner and nozzle characteristics table”. Once the regulation has been completed, replace the seal on the by-passes using paint or similar materials.

42

Image 8
Contents Contents Introduction Instructions for Safe and Proper USEPlate Must not be Removed This rating plate must never be removed Installation of the ApplianceElectrical connection Ventilation requirements Replacement of nozzles on the hob Adaptation to Different Types of GASBurner and nozzle characteristics table Arrangement of burners on cooking hobRegulation of minimum for LPG Adjustment of minimum for natural gasFinal Operations Positioning and levelling of the appliance Mounting the rear top upstandDescription of Symbols Thermostat Knob Selection of cooking temperature is carriedFunction Switch Knob Description of ControlsCooking HOB Burner Command Knob Delayed start cooking Manual mode cookingAnalog Programmer Regolazione delloraList of Functions Setting the timeElectronic Analogue Clock on some models only Minute-minder Programming Demo Function USE of the Cooking HOB Lighting of the cooking hob burnersDiameter of containers Practical advice for using the cooking hob burnersUSE of the Oven Storage drawer Oven LightCooling fan system Available Accessories Function Switch Thermostat Selector Switch from 50 to 250C Cooking HintsTraditional cooking Hot-air cookingMake sure that the oven door is closed during cooking Function Switch Thermostat Switch AT MaximumGrill cooking Function Switch Thermostat Switch from 50 to 250C Function Switch Thermostat Switch in PositionHot-air grilling DefrostingFunction Switch Thermostat Switch from 50 to 200C Spit cookingTraditional Cooking Recommended cooking tableHOT-AIR Cooking Cleaning of cooking hob components Cleaning and MaintenanceCleaning stainless steel Cleaning of the oven Do not USE a Steam JET for Cleaning the Inside of the OvenBurner caps, flame cap crowns and burners Ignition plugs and thermocouplesSelf-cleaning liners Using the self-cleaning linersLooking after the self-cleaning liners Assembling the self-cleaning linersExtraordinary Maintenance Replacement of light bulbLubrication of gas taps Removing the doorOven door seal