True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
ELECTRICAL INSTRUCTIONS
Step 4
NOTE
Hard wiring for a 30 amp circuit is required on spe- cific Bakery Cases.
A.Before your new unit is connected to a power supply, check the incoming voltage with a volt- meter. If anything less than 100% of the rated voltage for operation is noted, correct immedi- ately.
B.Models equipped with 9 ft. (3 m) power cord must be powered at proper operating voltage at all times.
Refer to cabinet data plate for voltage.
True requires that a sole use circuit be dedicated for the unit.
WARNING
Compressor warranties are void if compressor burns out due to low voltage.
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - Remove lower rear grill. Wiring diagram is positioned on the ballast box inside lower rear of the cabinet.
6 | www.truemfg.com | 6 |