RADIO RECEPTION
MANUAL TUNING
1 Press TUNER/BAND repeatedly to select the desired band.
FM 
AM 
When TUNER/BAND is pressed while the power is off, the power is turned on directly.
2Press f DOWN or g UP to select a station.
Each time the button is pressed, the frequency changes. When a station is received, “TUNE” is displayed for 2 seconds. During FM stereo reception, “1” is displayed.
1TUNE
PRESETTING STATIONS
The unit can store a total of 32 preset stations. When a station is stored, a preset number is assigned to the station. Use the preset number to tune in to a preset station directly.
1Press TUNER/BAND to select a band, and press f DOWN or g UP to select a station.
2Press a SET to store the station.
A preset number beginning from 1 in consecutive order for each band is assigned to the station.
Preset number
To search for a station quickly (Auto Search)
Keep f DOWN or g UP pressed until the frequency starts to change rapidly. After tuning in to a station, the search stops. To stop the Auto Search manually, press f DOWN or g UP.
•The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control so that “MONO” appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above so that “MONO” disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNER/BAND. To reset the interval, repeat this procedure.
NOTE
When the AM tuning interval is changed, all preset stations are cleared. The preset stations have to be set again.
3Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations for all the bands have already been stored.
NOTE
“FULL” is displayed if you attempt to store more than 32 preset stations.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly.
1Press TUNER/BAND to select a band.
2Press numbered buttons 0-9 and +10 to select a
preset number.
Example:
To select preset number 20, press +10, +10 and 0. To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
Press TUNER/BAND to select a band. Then, press d repeatedly or turn MULTI JOG.
Each time d is pressed, the next ascending number is selected.
To clear a preset station
Select the preset number of the station to be cleared. Then, press s CLEAR, and press a SET within 4 seconds.
The preset numbers of all other stations in the band with higher numbers are also decreased by one.