SETTING THE CLOCK
1Press CLOCK.
The clock is displayed. (The “:” between the hours and minutes flashes.)
2Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute. for gis also available in place of MULTI JOG. Holding these buttons down will vary the time rapidly.
3Press ENTER or a.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK before completing step 3 to restore the previous time setting. This cancels any new setting.
To view the clock when another display is in the display
Press CLOCK. The time is displayed for 4 seconds and then the original display reappears. However, the clock cannot be displayed during recording.
To switch to the 24-hour standard
Press CLOCK and then press s within 4 seconds.
Repeat the same procedure to restore the
In the
If the clock display flashes
If the display flashes when the clock is displayed, it indicates that the clock has stopped due to a power failure or the removal of the power cord. The current time needs to be reset.
NOTE
If the
SOUND
AUDIO ADJUSTMENTS
VOLUME
Turn VOLUME on the main unit, or press VOL on the remote control.
The volume level is displayed as a number from 0 to MAX (50). The volume level is automatically set to 20 when the power is turned off with the volume level set to 21 or more.
To change the left/right balance
Press MANUAL SELECT on the remote control. “L/R” is displayed for 4 seconds. Press r DOWN or t UP on the remote control within these 4 seconds.
•The front speakers level for the Dolby Digital, Dolby Pro Logic and DSP Surround systems is changed as well.
BBE SYSTEM
The BBE system enhances the clarity of
Press BBE.
Each time it is pressed, the level changes. Select one of the three levels, or the off position to suit your preference.
NOTE
•When playing back a tape recorded with BBE, set BBE off to avoid distorted high frequency sound.
•The BBE system cannot be turned on when digital input is selected or Dolby Pro Logic is activated (“Can’t USE” is displayed). If either of these two operations is performed when the BBE system is activated, BBE is automatically canceled.