LISTENING TO EXTERNAL SOURCES
PLAYING AN EXTERNAL ANALOG SOURCE
To play equipment connected to either the VIDEO1/DVD/AUX or the VIDEO2/LD/MD jacks, proceed as follows.
1Select input.
To play the equipment connected to the VIDEO1/DVD/AUX jacks, hold down VIDEO1/DVD/AUX.
To play the equipment connected to the VIDEO2/LD/MD jacks, hold down VIDEO2/LD/MD.
“ANALOG” and “DIGITAL” appear alternately on the display. Release the button when “ANALOG” is shown.
Analog input from your equipment is selected as the source.
2Play the connected equipment.
To change the source name display
When the analog source is selected with VIDEO1/DVD/AUX, “VIDEO1” is displayed initially as the source name. It can be changed to “DVD” or “AUX”.
Similarly, “VIDEO2” is initially displayed for the analog source selected with VIDEO2/LD/MD, but can be changed to “LD” or “MD”.
With the power on, hold down the desired function button (VIDEO1/DVD/AUX or VIDEO2/LD/MD) and press POWER repeatedly to select a name.
To adjust the sound level of the external source
This unit is equipped with the overload indicator. When analog signal input from the connected equipment is too high, “OVERLOAD” lights up continuously on the display.
When this occurs, or when the sound level of the external source is much lower than that of other function sources, adjust it as follows.
1Hold down either VIDEO1/DVD/AUX or VIDEO2/LD/MD to select analog input and play the equipment.
2Press for gso that the sound level becomes the same as that of other function sources.
NOTE
•During recording, the sound level cannot be adjusted.
•Only the sound level for analog external sources can be adjusted. If f or g is pressed when a digital external source is selected, the sound level for the corresponding analog external source is changed.
PLAYING AN EXTERNAL DIGITAL SOURCE
To play equipment connected to either the DIGITAL IN OPTICAL or the DIGITAL IN COAXIAL jack, proceed as follows.
1Select input.
To play the equipment connected to the DIGITAL IN OPTICAL jack, hold down VIDEO1/DVD/AUX.
To play the equipment connected to the DIGITAL IN COAXIAL jack, hold down VIDEO2/LD/MD.
“ANALOG” and “DIGITAL” appear alternately on the display. Release the button when “DIGITAL” is shown.
The DIGITAL indicator lights up on the display, and digital input from your equipment is selected as the source.
2Play the connected equipment.
To play Dolby Digital software
This unit is equipped with a Dolby Digital decoder. You can enjoy
To play Dolby Digital software, see section “Dolby Surround” (pages 21 to 24).
NOTE
•This unit supports Dolby Digital bitstream signals, and linear PCM signals with a sampling frequency of 32 kHz, 44.1 kHz or 48 kHz. This unit cannot play software whose sampling frequency is 96 kHz.
•Some DVD players connected digitally to this unit may cause noise during some DVD operation such as when searching a disc, skipping a chapter, etc.