Aiwa XR-MD95 manual Timer Play and Timer Recording, Within 4 seconds, press the 1I button

TIMER PLAY AND TIMER

RECORDING

SHIFT

POWER

The unit can be turned on at a specified time every day with the built-in timer.

●Make sure the clock is set correctly. (See page 7.)

Use the remote control,

1 Press theTIMER button repeatedly while pressing the SHIFT button on the remote control to display

~ (for timer play) or 0 and - (for timer recording).

Q:for timer play

@and -: for timer recording

2 Within 4 seconds, press the 1I button.

The hour flashes

m

If you do not press the II button within 4 seconds, another operation may start.

3 Designate the hour of the timer-on time by pressing the 4+ or ➤ P button, and press the 11 button. Repeat to designate the minute of the timer-on time.

4 Select a source for timer play, or a source and a recording source (MD) for timer recording.

When selecting timer play

Press the - or - button repeatedly to select one of the source names, then press the II button.

When selecting timer recording

Press the < or ➤E button repeatedly to select one of the source and recording source names, then press the II button. FM (or AM) > MD : when recording from a radio broadcast on an MD

TAPE * MD : when recording from the equipment connected to the TAPE IN jacks

AUX E MD : when recording from the equipment connected to the AUX IN jacks

●Timer recording is not applicable for CD.

5 Select the duration for the timer-activated period with the ++ or ➤ > button, and press the II button.

The duration for the timer-activated period can be set between

5 and 240 minutes in 5-minute steps.

6 Prepare the source and the recording source.

To listen to a CD, load the disc.

To listen to a radio broadcast, select the desired band and

tune in to a station.

To listen to an MD, insert the MD,

To listen to the connected equipment, set the timer of the connected source (with an external timer) and prepare it for play,

To record from a radio broadcast on an MD, select the desired band and tune in to a station and insert the MD.

To record from the connected equipment on an MD, set the timer of the connected source (with an external timer) and prepare it for play, then insert the MD.

7 Press the POWER button to turn the system off after adjusting the volume and tone.

@or @ DZX13il remains on the display after the power is turned off (timer standby mode).

For timer play, when the timer-on time is reached, the system turns on and begins play with the selected source.

For timer recording, the system turns on one minute before the timer-on time and starts recording at the timer-on time. So be sure to complete the above steps 1 through 7 at least one minute before the timer-on time.

If the volume level was set to more than 25 when the power was turned off, it is automatically set to 25 when the unit turns on by the timer.

To check the specified time and source

Press the TIMER button while pressing the SHIFT button on the remote control. The selected source name, the timer-on time and the duration for the timer-activated period are displayed for 4 seconds.

To cancel timer standby mode temporarily

Press the TIMER button repeatedly while pressing the SHIFT button on the remote control so that “TIMER OFF” is displayed on the display.

To restore the timer standby mode, press again to display @ (and -).

Using the unit while the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, repeat step 6 to prepare the source and the recording source, and adjust the volume and tone.

m

●Timer play and timer recording will not begin unless the power is turned off.

●Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

ENGLISH 27