Whirlpool ED2KVEXVQ Connect Water Supply, Style, Connect to Water Line, Connect to Refrigerator

Page 8

Connect Water Supply

Read all directions before you begin.

IMPORTANT:

■Plumbing shall be installed in accordance with the International Plumbing Code and any local codes and ordinances.

■Use copper tubing or Whirlpool supply line, Part Number 8212547RP, and check for leaks.

■Install tubing only in areas where temperatures will remain above freezing.

TOOLS NEEDED:

Gather the required tools and parts before starting installation.

■Flat-blade screwdriver

■⁷⁄₁₆" and ¹⁄₂" open-end wrenches or two adjustable wrenches

■¹⁄₄" nut driver

Connect to Water Line

IMPORTANT: If you turn the refrigerator on before the water line is connected, turn the ice maker OFF.

1.Unplug refrigerator or disconnect power.

2.Turn OFF main water supply. Turn ON nearest faucet long enough to clear line of water.

3.Use a quarter-turn shutoff valve or the equivalent, served by a ¹⁄₂" copper household supply line.

NOTE: To allow sufficient water flow to the refrigerator, a minimum ¹⁄₂" size copper household supply line is recommended.

A

B

5.Place the free end of the tubing into a container or sink, and turn on main water supply to flush out tubing until water is clear. Turn off shutoff valve on the water pipe.

NOTE: Always drain the water line before making the final connection to the inlet of the water valve, to avoid possible water valve malfunction.

6.Bend the copper tubing to meet the water line inlet, which is located on the back of the refrigerator cabinet as shown. Leave a coil of copper tubing to allow the refrigerator to be pulled out of the cabinet or away from the wall for service.

Connect to Refrigerator

Style 1

1.Unplug refrigerator or disconnect power.

2.Remove and discard the short, black plastic part from the end of the water line inlet.

3.Thread the nut onto the end of the tubing. Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

NOTE: To avoid rattling, be sure the copper tubing does not touch the cabinet’s side wall or other parts inside the cabinet.

A

B

C

D

A. Line to refrigerator

 

C. Ferrule (purchased)

B. Nut (purchased)

 

D. Supplied line from refrigerator

4.Install the water supply tube clamp around the water supply line to reduce strain on the coupling.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

 

C

 

D

A. Bulb

C. Copper tubing (to refrigerator)

B. Nut

D. Household supply line (½" minimum)

4.Now you are ready to connect the copper tubing to the shutoff valve. Use ¹⁄₄" (6.35 mm) OD soft copper tubing to connect the shutoff valve and the refrigerator.

■Ensure that you have the proper length needed for the job. Be sure both ends of the copper tubing are cut square.

■Slip compression sleeve and compression nut onto copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

A B

C

A. Compression sleeve

C. Copper tubing

B. Compression nut

 

Style 2

1.Unplug refrigerator or disconnect power.

2.Remove and discard the plastic part that is attached to the inlet of the water valve.

3.Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten.

4.Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help avoid damage to the tubing when the refrigerator is pushed back against the wall.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

 

A

 

B

 

C

 

D

 

E

A. Tube clamp

D. Compression nut

B. Tube clamp screw

E. Valve inlet

C. Copper tubing

 

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Refrigerator Safety Refrigerator User InstructionsBefore You Throw Away Your Old Refrigerator or Freezer Installation InstructionsUnpack the Refrigerator Door Removal, Leveling and Alignment Tools NeededRemove the wiring clip using a ¹⁄₄ hex-head socket wrench Replace the Doors and Hinges Handle Installation and Removal To Install the Handles Leveling and Door Closing Door AlignmentStyle 2 Slide-on Parts Included Door handles LocationRequirementsTo Remove the Handles Electrical Requirements Water Supply RequirementsRecommended Grounding Method Reverse Osmosis Water SupplyConnect Water Supply StyleConnect to Water Line Connect to RefrigeratorInstalling the Filter Status Indicator on some models Install Air FilterInstalling the Air Filter on some models Install Produce Preserver Using the Controls Adjusting the ControlsCondition Temperature Adjustment Refrigerator USEConvertible Drawer Temperature Control Crisper Humidity ControlChilled Door Bin Water and Ice DispensersTo Dispense Water To Dispense IceIce Maker and Storage Bin onsomemodels Turning the Ice Maker On/OffRemoving and Replacing Ice Storage Bin StyleCleaning To Clean Your RefrigeratorRefrigerator Care Water Filtration SystemTroubleshooting Refrigerator OperationMotor seems to run too much Refrigerator is noisyTemperature and Moisture Temperature is too warmIceand Water Humid room? Contributes to moisture buildupAccessories Performance Data Sheet Water Filtration SystemLimited Warranty Items Excluded from WarrantyThis limited warranty does not cover Disclaimer of Implied WarrantiesInstrucciones Para EL Usuario DEL Refrigerador Seguridad DEL RefrigeradorAntes de tirar su viejo refrigerador o congelador Instrucciones DE InstalaciónDesempaque el refrigerador Remoción, nivelación y alineamiento delas puertas Herramientas NecesariasQuite las puertas Vuelva a colocar las puertas y las bisagrasNivelación y cierre de la puerta Alineamiento de la puertaCómo instalar y remover las manijas Para instalar las manijasPara quitar las manijas Estilo 1 Tornillos opresoresRequisitos de ubicación Requisitos eléctricosRequisitos del suministro de agua Método de conexión a tierra recomendadoEstilo Conexióndel suministro de aguaSuministro de agua de ósmosis inversa Instalación del filtro de aire Cómo terminar la instalaciónCómo instalar el filtro de aire en algunos modelos En los modelos con muescasEn los modelos sin muescas Reemplazo del filtro de aireCómo ajustar los controles Uso de los controlesInstalación del indicador de estado en algunos modelos Control de temperatura del cajón convertible Condición Regulación DE LA TemperaturaPara despachar agua Depósito enfriador de la puertaDespachadores de agua y hielo Para encender y apagar la fábrica de hielo Fábrica dehielo y depósitoPara despachar hielo Luz de estado del filtro de agua Sistema de filtración de aguaCómo quitar y volver a colocar el depósito de hielo Limpieza Cómo cambiar los focosPara limpiar su refrigerador Cómo cambiar el filtro de aguaSolución DE Problemas Funcionamiento delrefrigeradorEl refrigerador no funciona Parece que el motor funciona excesivamenteNota Esto es una indicación de baja presión de agua Temperatura y humedadHielo y agua Accesorios Hoja DE Datos DEL Rendimiento Sistema de filtración de aguaWhirlpool Corporation Garantía LimitadaExclusiones DE LA Garantía Esta garantía limitada no cubreWhirlpool Brand Home Appliances Instructions Dutilisation DU Réfrigérateur Sécurité DU RéfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Instructions DinstallationDéballage duréfrigérateur Retrait, réglage de laplomb et alignement de la porte Outillage NécessaireRemplacer les portes et les charnières Enlever les portesImportant Ne pas retirer l’une des vis a Nivellement et fermeture de la porte Alignement des portesInstallationet démontage des poignées Installation des poignéesRetrait des poignées Style 1 Vis de blocageExigences demplacement Méthode recommandée de mise à la terreSpécifications électriques Spécifications del’alimentationen eauRaccordement de la canalisation deau Alimentation en eau par osmose inversePression de leau Raccordement à une canalisation d’eauInstallationdu filtre à air Achever l’installationInstaller le sachet deconservation Pour produits frais Installation du filtre à air sur certains modèlesRemplacement du filtre à air Modèles avec encochesUtilisation des commandes Installation du témoin lumineux sur certains modèlesAjustement des commandes Utilisation DU RéfrigérateurAlarme de porte entrouverte Condition Ajustement DE LA TempératureRefroidissement On/Off marche/arrêt Caractéristiques supplémentaires Fast Ice glace rapideDistributeurs d’eauet de glaçons Commande de température dans Le tiroir convertibleCompartiment fraîcheur dans la porte Distribution d’eau Distribution de glaceMise en marche/arrêt de la machine à glaçons Pour retirer et réinstaller le bac à glaçonsMachine à glaçons et bac dentreposage Entretien DU Réfrigérateur Système de filtrationde leauNettoyage Nettoyage de votre réfrigérateurFonctionnement du réfrigérateur Remplacement des ampoules d’éclairageDépannage Les portes sont difficiles à ouvrir Température et humiditéGlaçons et eau Heures pour la fabrication de nouveaux glaçons Les glaçons sont creux ou petitsRemarque Cela indique une faible pression de leau Accessoires Nettoyant et poli pour acier inoxydableFiltre à eau Filtre à airFeuille DE Données SUR LA Performance Système de filtration d’eauGarantie DE Gros Appareil Ménager Whirlpool Corporation Garantie LimitéeÉléments Exclus DE LA Garantie La présente garantie limitée ne couvre pasPage W10297006C EN/FR PN W10281961C Whirlpool Corporation All rights reserved
Top Page Image Contents