Vacation and Moving Care
Eiectn’cai Shock Hazard
Make sure the ice maker is disconnected from the main power suppty before removing lower access panel.
Failure to do so could result in electrical shock or personal injury.
To shut down the ice maker:
1.Turn the Cycle Control Knob to “OFF,”and disconnect electrical power supply to the ice maker.
2.Remove all ice from storage bin.
3.Shut off the water supply.
4.Remove the two screws in the lower grille area and the one screw from the center of the front panel support. (Open bin door slightly for better access to screw.) Pull forward and down to remove the lower access panel.
5.Disconnect the inlet and outlet lines to water valve. Allow these lines to drain and then reconnect to the valve.
6.Replace lower access panel and screws.
7.Remove water from drain lines and drain water pan.
8.Before using again, clean the ice maker and storage bin.
NOTE: All components of the ice maker are permanently lubricated at the factory. They should not require any additional oiling throughout the normal life of the machine.