Broan E55000 manual Install, Ducted NON, Ducted Hoods

INSTALL THE
			MOUNTING	WALL FRAMING
HOOD			SCREWS
			(3.9x9.5mm)
DUCTED	AND	NON-		MOUNTING
DUCTED HOODS		people
Note: at least two				BRACKET
will be required to mount the				RECTANGULAR
hood.
1. Raise	the hood into its			CUTOUT
mounting position.

2.Align the rectangular opening on the back of

the hood with the wall-
mounting bracket. Gently		MOUNTING SCREWS
lower the	hood until it
securely	engages the	(4.8x38mm)			FIG.14
bracket. Fig. 14.
3. Level the hood with (2) 3.9x9.5mm			MOUNTING
mounting	screws and secure with (4)		SCREWS	ELECTRICAL
4.8x38mm mounting screws. Use drywall			(3.9x9.5mm)	SYSTEM
anchors provided if wall studs or framing				PLATE
are not available. Fig. 14.

4.Mount the electrical system plate attaching it with (3) 3.9x9.5 mounting screws. Fig.15.

5.On ducted hoods, attach 6” round metal duct between the hood’s blower collar and duct that leads to the outside location.

6.On non-ducted hoods, attach 5” round metal expandable duct between the 5”-6”

adapter on the hood and the connector on	FIG.15
the plenum.

7.Tape all duct joints to make them secure and air tight.

8.Plug the power cord into the electric wall receptacle. Tuck excess cord behind the flue.

- 12 -