Installation Instructions
Unit Mounting Instructions
Continued
Compressor Accumulator Capacitor
S1C
Shown
Filter Drier
Lag Bolts
5.Insert lag bolts through the holes in the bottom of the unit and tighten to secure.
S1C
Shown
6.Insert lag bolts through the holes in the feet on the back of the unit and tighten to secure.
7.Replace the front panel, do not tighten the side screws at this time.
ELECTRICAL WIRING
1.All electrical wiring must be run accord- ing to NEC and local codes.
2.Refer to the unit rating plate for voltage, minimum circuit ampacity and over cur- rent protection requirements.
rating plate 
3.Use only HACR type breakers or time delay fuses. Select the wire size accord- ing to the ampacity rating.
4.To access electrical connections and wiring diagram:
a)Remove the screws on the side panel adjacent to the back panel.
b)The screws adjacent to the front panel should already be loose (don't remove them).
Side Discharge Condensers | 5 | www.enviromaster.com |