Desa SBVBP installation manual REMOVING/REPLACING Glass Door

Page 17

CAST IRON STOVE AND B-VENT BURNER SYSTEM INSTALLATION

Installing Optional Wireless Hand-Held Remote Control Accessories - GHRCB and GHRCTB Series (Cont.) Removing/Replacing Glass Door

17

CAST IRON STOVE AND B-VENT BURNER SYSTEM INSTALLATION

Continued

Installing 9-Volt Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit

2.Attach terminal wires to a 9-volt battery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote control unit.

	Battery Cover	Remote
	Terminal Wires	Control
	Terminal Wires	Unit
		Unit
	9-Volt
	Battery
		Battery Housing

Figure 38 - Installing Battery in Hand-Held Remote Control Unit (GHRCB Only)

9-Volt	Terminal Wires
Battery

Remote

Control Unit

Battery
Housing	Battery Cover
	Battery Cover

Figure 39 - Installing Battery in Hand-Held Remote Control Unit (GHRCTB Only)

REMOVING/REPLACING GLASS DOOR

You must remove glass door to install logs, lava rock, and ember material. To remove glass door, you must first remove the front panel on stove body.

CAUTION: Do not operate this burner system with a broken glass door panel or without the glass door panel securely in place. For replacement part infor- mation see Replacement Parts, page 26.

1.If stove front panel is still installed, remove 2 bolts from bot- tom of stove and one from the top of stove to remove front panel (see Figure 40). For the Oxford stove the middle grate will need to be removed to remove the top bolt.

2.Remove the screws from the 2 tabs at the top of the glass door while holding door securely keeping it from falling forward (see Figure 41).

3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 41).

4.To replace glass door, follow the above instructions in reverse.

Bolt

Stove Front

Panel

Middle

Grate

Bolt

Figure 40 - Removing Front Panel from Stove (Oxford™ Model Shown)

Screw

Glass Door

Figure 41 - Removing Glass Door from Burner System

For morevisit www..com

112127-01B

Image 17

Contents For Your Safety What to do if YOU Smell GAS For Your SafetyVH series Stove Series StoveSafety Information Table of ContentsProduct Identification Local Codes Product FeaturesPRE-INSTALLATION Preparation Stove Body Assembly Cast Iron Stove and B-VENT Burner System AssemblyRemoving Screen Optional Removing Front Surround PanelAmity Models Oxford or Victor Hearth ModelsInstalling Optional Blower Accessory Installing B-VENT Burner System Into Stove BodySecurely in place before venting pipes are installed Installing Rear CoverInstallation Precautions Venting InstallationVertical Checking Vent CapacityRelining Systems High Altitude InstallationChimneys Cast Iron Stove and B-VENT Burner System Installation Troubleshooting Venting ProblemsFlue GAS Spillage Causes of Spillage and Corrective ActionInstallation Items Needed Installing GAS Piping to Stove LocationPressure Testing Gas Supply Piping System Connecting STOVE/BURNER System to GAS SupplyChecking GAS Connections Test Pressures In Excess Of 1/2 Psig 3.5 kPaInstalling Optional Wall Mounted Thermostat GWMT1 Installing Optional Wall Mount Switch GWMS2Pressure Testing Burner System Gas Connections Will occurInstalling Battery in Receiver Installing Remote ReceiverREMOVING/REPLACING Glass Door Installing 9-Volt Battery in Hand-Held Remote Control UnitRemove glass door. See Removing/Replacing Glass Door, Installing LOGS, Lava ROCK, and Glowing EmbersOperating Stove with B-VENT Burner System For Your Safety Read Before LightingLighting Instructions To Turn OFF GAS To ApplianceON/OFF Series Models Ghrcb and Cghrcb Operating Stove with Vent Burner SystemOptional Remote Thermostat Series Operation Pilot Assembly Operating Optional Blower AccessoryInspecting Burners Operating Optional GWMT1 Wall Mounted ThermostatGlass Door Cleaning MaintenancePilot and Burners LogsObserved Problem Possible Cause TroubleshootingObserved Problem Possible Cause Remedy Above Gas leak. See Warning statementTechnical Service Replacement PartsWiring Diagram Service HintsSbvbnd Sbvbpd SpecificationsModels Sbvbnd and Sbvbpd Illustrated Parts BreakdownKEY Part Number Description QTY Parts ListVictor Hearth Stove Body Indicates Color Suffix Designation Oxford AmityStove Body Description QTY Indicates Color Suffix DesignationReceiver and HAND-HELD Remote Control KIT Ghrcb and Cghrcb AccessoriesTHERMOSTATICALLY- Controlled Blower KIT CDA3620TB Stove Hearth Base GC10SPAOwners Registration Form Postage Required 112127-01B Warranty Information