Using 3in1 detergents
These products are detergents with a combined cleaning, rinsing and salt function.
When the 3in1 function is activated,
–the addition of special salt and rinse aid from the respective dispenser is prevented.
–If the salt and rinse aid dispensers are empty, this is not indicated.
–The dishwashing cycles can be up to 30 minutes longer.
3If you want to use 3in1 detergents, check whether these detergents are suitable for your water hardness. (Follow the manufacturer’s in- structions.)
If you want to use 3in1 products
1.Press the ON/OFF button.
2.Go to the 3 IN 1 option.
3.Set the value to ON (see section “Adjusting an op-
tion/setting” 
symbol lights up in the symbol line.
Before the start of the dishwashing cycle put 3in1 detergent in the detergent dispenser.
3As the rinse aid inflow is automatically switched off when the 3in1 function is activat- ed, it may come about because of the different quality standards in the 3in1 detergent, that the dishes do not dry sufficiently.
If this happens, proceed as follows (see sec- tion “Adding rinse aid”):
•Fill up the dispenser (if this is empty) with rinse aid.
•Set rinse aid dosage to “2” mechanically.
•Activate rinse aid inflow.
If you do not want to use 3in1 products any more
If you want to stop using 3in1 products, please do the following:
•Deactivate the 3in1 function.
•Fill up the dispensers for salt and rinse aid again.
•Switch the water softener to the highest setting and perform up to three normal cycles without loading any dishes.
•Then set the water softener to the water hardness in your area.
If you want to use 4in1 products
When using "4 in 1" detergents that integrate also anti- glass corrosion agent into "3 in 1" formula, please follow the same indication as given for "3 in 1" detergents.
22