Setting electronically:
1.Press the ON/OFF button.
3If indicators for the programme buttons are lit, a dishwashing cycle is activated. The dish- washing cycle must be deselected:
Press function buttons 1 and 2 simultaneously for approx. 2 seconds.
All additional wash programme button indica- tors will go out.
2.Press function buttons 1 and 2 simultaneously and keep them pressed.
The LED indicators for function buttons 1 to 3 will flash.
3.Press function button 1.
The LED indicator for function button 1 will flash. The
4.Pressing function button 1 increases the hard- ness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
5.When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
If the water softener is set electronically to “1”, this switches off the control indicator for dishwasher salt.
| Water hardness |
| Adjusting the hardness setting | Indication on the | |
|
|
|
|
| |
in °d1) | in mmol/l2) | Range | Manual | Electronic |
|
51 - 70 | 9,0 - 12,5 |
|
| 103) | 10L . |
43 - 50 | 7,6 - 8,9 |
|
| 9 | 9L |
37 - 42 | 6,5 - 7,5 | IV | 1 | 8 | 8L |
29 - 36 | 5,1 - 6,4 |
|
| 7 | 7L |
23 - 28 | 4,0 - 5,0 |
|
| 6 | 6L |
|
| ||||
|
|
|
|
|
|
19 - 22 | 3,3 - 3,9 | III |
| 5 | 5L |
15 - 18 | 2,6 - 3,2 |
| 4* | 4L | |
|
| ||||
|
|
|
|
|
|
11 - 14 | 1,9 - 2,5 | II | 0* | 3 | 3L |
4 - 10 | 0,7 - 1,8 | I/II |
| 2 | 2L |
|
|
|
|
|
|
below 4 | below 0.7 | I |
| 1 | 1L |
| no salt necessary | ||||
|
|
|
|
| |
|
|
|
|
|
|
1)(°d) German degree, measure of the hardness of water
2)[mmol/l] millimol per litre, international unit for water hardness
3)On this setting the length of the dishwashing cycle may be slightly longer. *) factory setting
10