Sherwood RD-8601 Using Functions Of Remote Control, Entering a setup code, English

USING FUNCTIONS OF REMOTE CONTROL

•This remote control can control up to 8 different components.

•Before operating audio and video components other than this receiver with using this remote control, the setup code for each component should be entered.

•For system remote control operation, “000” was stored previously in the memory of the device button “CD” for Sherwood CD player, “DVD” for Sherwood DVD player and “AUX” for Sherwood tape deck respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.

Entering a setup code
1	Turn on the component you want to control.	2	Find the setup codes according to the type
			and the brand name of your component,
			referring to “Setup Code Table” on page 52.
3	Press and hold down both the “ENTER”	4	Enter a 3 digit code, aiming the remote control
	button and the desired one of the DEVICE		at the remote sensor on the component.
	buttons for more than 1 second.		Example) When entering “001”.

AUD	CD	AUX	TV
VCR	DVD	SAT	CBL

		TUNER
0	0	1
ENTER

		• If entering is performed successfully, the LED will
		flicker twice.
		• To be sure that the setup code is correct, press the
• The LED will flicker once.		POWER(or STANDBY) button.
		If your component is tuned off, the setup code is correct.
Note:		• When your component is not turned off, repeat the
• The “AUD” button is unavailable for the audio		above steps	to , trying each code for your
components other than this receiver.		component until you find one that works.
		Notes:
		• If the LED did not flicker twice, then repeat the above
		steps to	and try entering the same code again.
		• Manufacturers may use different setup codes for the
	Repeat the above steps to for each of	same product category. For that reason, it is important
5		that you check to see if the code you have entered
	your components.	operates as many controls as possible. If only a few
		functions operate, check to see if another code will
		work with more buttons.
		• When operating a Sherwood CD player or tape deck
		using the system remote control, aim the remote
		control at the REMOTE SENSOR on this receiver.
		However, in case of Sherwood DVD player and MD
		recorder, aim it at the REMOTE SENSOR on the
		corresponding component.

16

ENGLISH