Setting The Speaker Setup, Preparations, English

SETTING THE SPEAKER SETUP

•After you have installed this receiver and connected all the components, you should adjust the speaker settings for the optimum sound acoustics according to your environment and speaker layout.

•Even when you change speakers, speaker positions, or the layout of your listening environment, you should adjust the speaker settings, too.

ENGLISH

S PE A K ER S E T UP

A U TO

MA NUA L

: MOV E
O S D : BA CK	E N T E R : S E L .

To set the speaker setup automatically(Auto Speaker Setup)

To set the speaker setup manually(Manual Speaker Setup)

Note:

•Because the microphone for Auto Speaker Setup is designed for use with this receiver, to use the auto speaker setup function, do not use a microphone other than the one supplied with this receiver.

When selecting the AUTO SPEAKER SETUP

•Auto Speaker Setup lets you avoid troublesome listening-based speaker setup and achieve good surround sound.

You should connect the supplied microphone to the SETUP MIC jack so that this receiver can analyze the information from a series of test tones emitted from speakers and can adjust the size, distance and sound level of each speaker automatically.

•If you want to personalize your speaker setup and channel level setup by making the settings manually, perform the “When selecting the MANUAL SPEAKER SETUP” procedure on page 43, “Adjusting each channel level with test tone” procedure on page 32 and “Adjusting the current channel level”on page 33.

Preparations

1. Connect the supplied microphone to the SETUP MIC	2. Place the microphone on a flat level surface at your
jack on the rear panel,(For details, refer to	normal listening position.
“CONNECTING MICROPHONE” on page 10)	• If possible, use a tripod, etc. to attach the microphone
	at the same height as your ears would be when you
	are seated in your listening position.
	• Ensure there are no obstacles between the speakers
	and the microphone.

1	Press the CURSOR UP( )/DOWN( )
	buttons to select the AUTO SPEAKER
	SETUP, then press the ENTER button.

ENTER

A U TO SE T UP

A L L CH A NNE L

F L - C - F R - SR - S L

F L - F R - SR - S L

F L - C - F R

F L - F R

: CU TOF F	8 0 H z Enter : S T AR T
: SW Yes	: MOV E OSD : B AC K

2	Press the CURSOR UP( )/DOWN( )/
	LEFT( )/RIGHT( ) buttons to specify the
	setting condition according to the number of

speakers installed and speakers’ frequency characteristics.

• To specify the layout of the installed speakers, press the CURSOR UP( ) or DOWN( ) button.

•To specify the crossover frequency, press the CURSOR LEFT( ) button.

You can specify the crossover frequency with the range of 40~130 Hz in 10 Hz intervals.

• To specify the subwoofer, press the CURSOR RIGHT( ) button.