At the desired parameter, adjust it as desired.
2
ADJUST
or
ADJUST
•If the parameter display disappears, start from the step again.
3 | Repeat the above steps | and | to adjust |
other parameters. |
|
|
ENGLISH
Selecting the desired speaker layout for Dolby Virtual Speaker mode
•When selecting the Dolby Virtual Speaker Reference mode(“DOLBY (D) VS REF”) or the Dolby Virtual Speaker Wide mode(“DOLBY (D) VS WIDE”), you can select the desired one of different speaker layouts for actual speakers to be used.
•Press the PARAMETER button to select the desired speaker layout.
• Each time this button is pressed, the speaker layout mode changes depending on the selected Dolby Virtual Speaker mode as follows:
* In case of Dolby Virtual Speaker Reference mode,
2 SPK : When using 2 front speakers only
or | 3 SPK : When using 2 front and center speakers |
PARAMATER
* In case of Dolby Virtual Speaker Wide mode,
2 SPK : When using 2 front speakers only
3 SPK : When using 2 front and center speakers
4 SPK : When using 2 front and 2 surround speakers
5 SPK : When using 2 front, center and 2 surround speakers
Note : When the speakers are set to “None”, the corresponding speaker layout modes cannot be selected.
Adjusting each channel level with test tone
• The volume level of each channel can be adjusted easily with the test tone function.
Note : When the EXTERNAL IN is selected as an input source, the SPEAKER button is set to off or it is in the stereo mode, the test tone function does not work.
Enter the test tone mode.
1
T.TONE
MENU
•The test tone will be heard from the speaker of each channel for 2 seconds as follows:
FL | C | FR | SR | SB | SL |
|
| ||||||
Front Left | Center | Front Right | Surround | Surround | Surround | |
|
|
| Right | Back | Left |
SW
Subwoofer
•When the speaker setting is “N”, the test tone of the corresponding channel is not available.
32