SETTING THE CH LEVEL SETUP
CH L E V E L TR I M
R E F . 1 |
|
|
|
|
|
F L - - - - - - - | - - - - - - - | 0 |
|
| |
C - - - - - - - | - - - - - - - | 0 |
|
| |
F R - - - - - - - | - - - - - - - | 0 |
|
| |
S R - - - - - - - | - - - - - - - | 0 |
|
| |
: MOV E | : CHANGE |
|
|
| |
O S D : B A CK EN T E R : MEMO |
| ||||
|
|
|
|
| |
|
|
|
| ||
|
| Preset memory mode |
CH L E V E L TR I M |
| |
S B - - - - - - - | - - - - - - - | 0 |
S L - - - - - - - | - - - - - - - | 0 |
SW - - - - - - - | - - - - - - - | 0 |
DD L - - - - - |
| 0 |
DT S L - - - - - |
| 0 |
: MOV E | : CHANGE |
|
O S D : B A CK | EN T E R : MEMO |
|
|
|
|
ENGLISH
Notes :
•Depending on the speaker settings and surround mode, etc., some channels cannot be selected.
•When the SPEAKER button is set to off, only the Front Left and Right channels can be selected.
•Only when the digital signals from Dolby Digital or DTS program sources that include LFE signal are input, “DD L”(Dolby Digital LFE) or “DTS L” can be selected.
Adjusting the current channel level
•You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory(“USER”), not into preset memory(“REF. 1”, “REF. 2”)
•After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes.(For details, refer to “Adjusting each channel level with test tone” on page 32.)
Press the CURSOR UP( )/DOWN( ) buttons to select the desired channel.
1
Press the CURSOR LEFT( )/RIGHT( ) buttons to adjust the level of the selected channel as desired.
2
•The LFE level can be adjusted within the range of
•In general, we recommend the LFE level to be adjusted
to 0 dB.(However, the recommended LFE level for some early DTS software is
Repeat the above steps | and | to adjust each channel level. |
3
48