GE JCS57 manual WQUESmONS?, USE this Problem Solver, Consumer information service

Page 32

w●●QUESmONS?

USE THIS PROBLEM SOLVER

PROBLEM

OWN WLL

NOT WORK

OVEN LIGHT DOES NOT WORK

FOOD DOES NOT BRO~ PROPE~Y

FOOD DOES NOT ROAST OR BAKE PROPERLY

OVEN ~LL NOT SELF-CLEAN (model JCP67)

OVEN NOT CLEAN AFTER CLEAN CYCLE (model JCP67)

AUTOMA~C OVEN

~ER DOES NOT WORK PROPERLY

POSS~LE CAUSE

●The plug on the range is not completely inserted in the electrical outlet.

●The circuit breaker in your house has been tripped, or a fuse has been blown.

●The oven controls are not properly set.

c The fight bulb is loose or defective. Tighten or replace.

●The switch operating the oven light is broken. Call for service.

●The OVEN SET knob not set at BROIL.

●The OVEN TEMP knob not set at BROIL.

●Door not left open to the broil stop position as recommended.

●Improper sheE position being used. See the Broiling Guide.

●Food is being cooked on hot pan.

●Cookware not suited for broiling.

●Murninum foil used on the broiler pan and rack has not been fhted properly and slit as recommended.

●The OVEN SET knob not set on BAKE.

●The OVEN TEMP knob not set correctly.

●Shelf position is incorrect.

c kcorrect cookware or cookware of improper size is being used.

●A foil tent was not used when needed to slow down browning during roasting.

●Automatic timer dids not set or not set properly. The clock must be set to time of day and the STOP dial must be set and advanced beyond the time noted on the oven clock.

●The STOP dial was not advanced for long enough.

●Both the OVEN SET and the OVEN TE~ knobs must be set at CLEAN settings.

●When the oven is seti-cleaned, a thick pile of spillover can leave a heavy layer of ash and insulate that area from further heat.

●The oven controls are not set properly.

●Heavily soiled ovens rquire 31/2-to4-hour clean time.

“Heavy spillovers should be cleaned up before starting the clean cycle.

●Check to be certain step by step directions were followed correctly. See the Automatic Timer and Clock section.

SURFACE LIGHT

DOES NOT WORK

SURFACE UNITS NOT FUNCTIOMNG

M you need more help.. cdl, The GE Answer Centerm

●The fluorescent light is loose or defective. Adjust or replace.

●Press the switch for 2 seconds. If the light does not come on, repeat.

●The switch operating the light is broken. Call for service.

●The surface units are not plugged in sofidly.

●The surface unit controls are not properly set.

toll free

800.626.2000

consumer information service

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents ~Use&nd&re & ln~llation Guid6 Save time and money Beforeyou request service ~LP US ~LP YOUYOU~ED Serwce If you receiveda damaged rangeHortant Safety Notice AWA~INWortmt S~W ~STRUC~ONS OvenSelf-Cleating Oven Sutiace CookingUnitsInstilkg the Range Leveltig the RangeJCS57 Explained 18, 19,27SU~ACE Controls How to Set the ControlsCooting Guide for Using Heat Settings Shace COOKWA~ ~S CookwareDeep Fat Frying Wok CookingTo Set the Minute Timer TimedBakingUses the AutomaticTimerSelf-CleaningUses the AutomaticTimer To Set the ClockQuestions and Answers Before Using YourOvenUSmG Your OWN Oven ControlsUsing Foil Correctlyin the Oven US~G Your OWNOven Interior Shelves Shelf PositionsBA~G Am MD BA~G How to Set the Range for Baking Rght OvenHow to The Bake Wght Oven BA~G ~ HD BA~G How to Set Immediate Start and Automatic Stop Right OvenHow to Set Delay Start and Automatic Stop Right Oven How to Set the Range for PreheatingLeft Oven Model JCP67 How to Set the Range for Bting Left Oven Model JCP67To set the oven for Baking, proceed as follows Can I Time Bake in the companion left oven model JCP67?Pan Placement BA~G W T-D BAmGOven Shelves FieheatingBaking Gtides CookiesPies CakesHow to Roast in the Right Oven How to Roast in the Left Oven Model JCP67ROAST~G Frozen RoastsHow to Brofiin the Wght Oven How to Brofi in the Left Oven Model JCP67Why are my meats not turning out as brown as they should? BROm~GMedium OPEM~G ~ SELF-CLEA~G OWN Before a Clean CycleHow to Set the Oven for Cleanhg After a Clean Cycle To Stop a Clean CycleWhy do I have ash left in my oven after cleaning? OPEM~G T~Sutiace Uni@and Drip Pans To remove a surface unitCA~ ~ Clemg ControlPanel and mobsLift-Up Cooktop Cleatig Under the Range@Q-0 Broiler Pan and GridTo replace the door CA~ Am CLEA~GLtit-Off Oven Door Oven Heating Elementi PorcelainEnamel CooktopBeforeyou Begin WARN~G E~~C~ Ground is REQU~D on ~IS APP~CE 11+= Immrtmt Wfen Waruihg WQUESmONS? USE this Problem Solver800.626.2000 Consumer information service Page NO~S WtillBeThere WARRAN~
Top Page Image Contents