CA~ ~ CLEMG
(continual)
ControlPanel and mobs
Clean up any spills or spatters with a damp cloth. Remove heavier soil with warm, soapy water.
Clean control panel with mild liquid dish detergent and a soft cloth. Rub control panel lightly.
CAUTION: Do not use abrasives of any kind on the control panel.
The control knobs may be removed for easier cleaning. To remove a knob, pull it straight off the stem. Wash the knobs in soap and water but do not soak.
Lift-Up Cooktop
Clean the area under the cooktop often.
To make cleaning easier, the entire cooktop may be lifted up and supported in the up position.
Be sure dl surface unib are turned off before raising the cooktop. Grasp the front sides of the cooktop and lift. The surface units and drip pans do not need to be removed before raising the cooktop, however, you may remove one to make raising the cooktop easier.
To lift the cooktop:
1.Remove all items which may slide off the cooktop.
2.With both hands, grasp the front edge of the cooktop.
3.Lift the cooktop.
4.Raise the support rod and let the cooktop rest on it.
Clean under the cooktop with hot, mild soapy water and a clean cloth.
To lower the cooktop:
1.Lift the cooktop and lower the support rod.
2.Lower the cooktop and allow it to lock into position.
Cleatig Under the Range
The area under the range can be reachedeastiy for cleaningby removingthe bottomdrawer. Toremove,pullthedraweroutalltheway,tiltupthe frontandremoveit. Toreplace,insertglidesatthe backof thedrawerbeyondthestopon rangeglides. Liftthedrawerif necessaryto inserteasily.Letthe frontof thedrawerdown,thenpushin to close.
BacksplashLight
Press the backsplash light switch for ON. Ress again for OFF.
To repiace the light located in the backsplash:
1.If the light cover has screws, remove the four screws that hold it in position. Two are located on top of the backsplash and two are located under the backsplash overhang.
2.If there are no screws or after they are removed, lift the cover away and twist out the fluorescent light.
CAUTION: Be sure the light is cool before removing.
3.Insert the new fluorescent light and twist into the lock position. (Check to make sure the new light operates. If not, the light maybe blown.)
4.Replace the backsplash cover and reinsert the screws that hold it into position (on some models).
24