Amana 8113P598-60 manual During the Self-Clean Cycle, After Self-Cleaning

Page 18

Care & Cleaning

5.Press the ▲ or ▼ pad to scroll through the self-cleaning settings.

HVy (Heavy Soil, 4 hours) MEd (Medium soil, 3 hours) LITE (Light Soil, 2 hours)

Choosing the soil level of the oven automatically programs the self-cleaning time.

6.After four seconds, CLEAN, DELAY and LOCK will appear in the display to show that the oven is set for a delayed clean operation. The delay time is displayed.

During the Self-Clean Cycle

When LOCK shows in the display, the door cannot be opened. To prevent damage to the door, do not force the door open when LOCK is displayed.

Smoke and Smells

You may see some smoke and smell an odor the first few times the oven is cleaned. This is normal and will lessen in time.

Smoke may also occur if the oven is heavily soiled or if a pan was left in the oven.

Sounds

As the oven heats, you may hear sounds of metal parts expanding and contracting. This is normal and will not damage the oven.

If the oven has already been set for a clean cycle and you wish to set a delay:

1. Press the Clean and Timer pads. (Press the Clean pad first)

DELAY flashes.

00:00 will appear in the display.

2.Press the ▲ or ▼ pad to set the amount of time you want to delay the cycle.

After four seconds, CLEAN, DELAY and LOCK will appear in the display to show that the oven is set for a delayed clean operation. The delay time is displayed.

When the Self-Clean cycle starts:

DELAY will turn off.

The clean time will appear in the display.

To cancel the Self-Clean cycle:

Press the Cancel pad.

All words disappear from the display.

All functions are canceled.

The time of day appears in the display.

After Self-Cleaning

About one hour after the end of the self-clean cycle, LOCK will turn off. The door can then be opened.

Some soil may leave a light gray, powdery ash. Remove it with a damp cloth. If soil remains after wiping, that means the clean cycle was not long enough. The soil will be removed during the next clean cycle.

If oven racks were left in the oven and do not slide smoothly after a clean cycle, wipe racks and rack supports with a small amount of vegetable oil to make them easier to move.

Fine lines may appear in the porcelain because it went through heating and cooling. This is normal and will not affect performance.

A white discoloration may appear after cleaning if acidic or sugary foods were not wiped up before the self-clean cycle. This discoloration is normal and will not affect performance.

Notes:

If the oven door is left open, “door” will flash in the display and a signal will beep until the door is closed and the Clean pad is pressed again.

If more than five seconds elapse between pressing the Clean pad and the ▲ or ▼ pads, the program will automatically return to the previous display.

The oven door will be damaged if the oven door is forced to open when LOCK is still displayed.

17

Image 18
Contents Troubleshooting 21-22 Important Safety InstructionsCare & Cleaning 16-19 Electric Smoothtop Easy Touch ControlTo Prevent Fire or Smoke Damage Recognize Safety Symbols, Words, LabelsInstructions Case of FireCooking Safety Important Safety InstructionsChild Safety Utensil SafetyCleaning Safety Self-Clean OvenImportant Safety Notice and Warning CooktopSurface Controls Setting the ControlsSuggested Heat Settings Dual ElementsSmoothtop Surface Tips to Protect Smoothtop SurfaceCookware Recommendations Canning and Oversize CookwareControl Panel Using the TouchpadsOven Cooking ClockTimer Fault CodesLocking the Control Oven Door Baking Differences Between Your Old and New Oven BakingCook & Hold Baking NotesDelay Cook & Hold Changing Temp F/C Keep WarmFavorite Keep Warm NotesBroil Notes Broiling ChartBroiling To set BroilAutomatic Shut-Off Sabbath Mode Adjusting the Oven TemperatureSabbath Mode Notes Oven Bottom Oven VentOven Light Oven RacksEasyRackTM select models Baking Layer Cakes on Two RacksBefore Self-Cleaning To set Self-CleanTo Delay a Self-Clean Cycle During the Self-Clean Cycle After Self-CleaningCare & Cleaning Cleaning ProceduresPart Procedure Movement, then wipe off excess oil FirstGlass Stainless SteelStorage Drawer MaintenanceOven Window Leveling LegsTo the self-clean cycle TroubleshootingProblem Solution Word is not displayedOff. This is normal What is Not Covered By These Warranties Warranty & ServiceWarranty If You Need Service33-41 25-2829-32 42-45Pour éviter un incendie ou des dommages par la fumée Les instructions de sécurité importantes et les paragraphesFamiliarisation avec l’appareil En cas d’incendieSécurité pour les enfants Cuisson et sécuritéFriteuses Table de cuissonUstensiles et sécurité Hottes d’extractionConserver ces instructions pour consultation ultérieure Four autonettoyantAvertissement et avis important pour la sécurité Nettoyer uniquement les pièces mentionnées dans ce guideCuisson sur la surface Boutons de commandeRéglage des commandes Suggestions de réglageSurface à dessus lisse Pour éviter les marques et les rayures Conseils de protection de la surface à dessus lisseRemarques sur le centre de réchauffage Pour éviter les tachesTests pour vérifier si les ustensiles ont un fond plat Recommandations sur les ustensilesUstensiles de grande taille et pour les conserves Test de la règleUtilisation des touches Tableau de commandeCuisson dans le four HorlogeVerrouillage des commandes et de la porte du four MinuterieCodes d’anomalie Remarques sur la cuisson courante au four Cuisson couranteCuisson et maintien Différences de cuisson entre l’ancien four et le nouveauCuisson et maintien différée Maintien au chaud FavoriRemarques sur la fonction maintien au chaud Tableau de cuisson au gril Cuisson au grilRemarques sur la cuisson au gril Programmation de la cuisson au grilAnnulation du mode sabbat Arrêt automatique Mode sabbatRemarques sur le mode sabbat Ajustement de la température du fourGrilles du four Changement de la température F/CÉvent du four Éclairage du fourGrille EasyRackMC Certains modèlesCuisson de gâteaux à étages sur deux grilles Programmation de l’autonettoyage NettoyageAvant l’autonettoyage Démarrage différé d’un cycle d’autonettoyageAprès le cycle d’autonettoyage Pendant le cycle d’autonettoyageRemarques Méthodes de nettoyage Pièce NettoyageVaporisant d’abord sur un linge ’excédentPorte, panneaux Entretien Problème Solution Recherche des pannesLa porte du four ne se déverrouille Les commandes et la porte sont peut-être verrouillées. VoirNettoyage recommandés. Voir Pas après l’autonettoyageNe sont pas couverts par ces garanties Garantie et service après-venteGarantie Si vous avez besoin d’aideEstufa Electrica con Control ‘Easy Touch’ 700 Cubierta Lisa Para Evitar un Incendio o Daño Causado por el Humo Fecha de CompraCanadá Instrucciones Generales En Caso de IncendioSeguridad para los Niños Seguridad al CocinarOllas Freidoras CubiertaSeguridad sobre el Uso de Utensilios Campanas de VentilaciónAviso y Advertencia Importante Sobre Seguridad Seguridad en la LimpiezaHorno Autolimpiante Conserve estas Instrucciones para Referencia FuturaProgramación de los Controles Cocinando en la EstufaControles Superiores Ajustes de calor sugeridosCubiertas Lisas Para evitar marcas y rayaduras Consejos para proteger la cubierta lisaNotas sobre el área calentadora Para evitar las manchasPrueba de las Ollas Planas Recomendaciones sobre los utensiliosUtensilios para preparar conservas y de tamaños grandes La prueba de la reglaUso de las Teclas Cocinando en el HornoPanel de Control ‘Clock’ RelojCódigos de Errores ‘Timer’ TemporizadorBloqueo de los Controles y de la Puerta del Horno Notas sobre Horneado ‘Cook & Hold’ Cocción y‘Bake’ Horneado Mantener Caliente‘Delay ‘Cook & Hold’ Cocción y Mantener Caliente Diferido‘Favorite’ Favorito ‘Keep Warm’ Mantener CalienteNotas sobre ‘Keep Warm’ Notas Sobre Asado a la Parrilla ‘Broiling’ Asar a la ParrillaTabla de Asar a la Parrilla Tiempo Approx AlimentosCierre Automático Modo Sabático Ajuste de la temperatura del hornoNotas Sobre el Modo Sabático Respiradero del Horno Cambio de la temperatura de F/CParrillas del Horno Posiciones de la ParrillaModelos selectos Parrilla ‘EasyRackMR’Horneado de Pasteles de Capas en Dos Parrillas Dos parrillas Use las posiciones 2 y 5 o 3 yPara diferir un ciclo de autolimpieza Para programar ‘Self-Clean’ AutolimpiezaAntes de la Autolimpieza Limpie el marco del horno, el marco deDespués del ciclo de autolimpieza Durante el ciclo de autolimpiezaNotas Procedimientos de Limpieza Pieza Procedimiento DE LimpiezaCuidado y Limpieza Mantenimiento Problema Solución Localización y Solución de AveríasCrema para Limpieza de Cubiertas. Ver pág Códigos de ErroresMarcas de metal Manchas y estrías marronesLo que no cubren estas garantías Garantía y ServicioGarantía Si necesita servicio